Ordered a replacement holder with a new ceramic igniter and installed it. The new unit would not quite fit correctly on the Metal stand. It took only a couple of minutes with a large file to remove some of the metal on each side of the metal prongs that locate the holder onto the stand. Once done, it was an easy assembly job and works just fine. Note: I ordered two of the Torx screws along with the holder and discovered this is a necessity since the old stainless screws have a barrel diameter that is wider than the Torx screws and won't go through the holes in the new holder. I suppose the holes could be drilled out but this is an extra step and the new Torx screws worked perfectly.