Unplug the range. Take the back top panel off (5 screws on my range, top and bottom left, top and bottom right and one top center). Then remove the knob (just pull slowly to remove the knob). Finally 2 screws to remove the switch from the panel.
Use a set of needle nose pliers to help get the spade connectors off (I took them off and connected them to the new switch one at a time so I didn't mess up where anything went).
2 screws in the front panel to remount the switch. Press the knob back on. 5 screws in the back to put the panel back on. Plug it back in and done.
Fixed the problem I was having with the burner not cycling.