I took of front panel by removing two screws at the indention at bottom of front panel. After receiving the two hoses, I had to cut the old hoses off they were old and hard. I removed the hose that went from the pump to the tub. Also removed the hose that went from the pump to the back side of the washer, that connected to the drain hose on the outside of the washer. I bought new hose clamps also thinking I should replace all so I wouldn't have to do it later. I put the hose on that went to the back of the washer and to the drain hose first, which also went to the pump. I also used new hose clamps to eliminate having to replace the old clamps later. Then I put on the hose that went from the tub to the pump also using new hose clamps. I through some clothes and soap in the washer and watched for leaks while the washer went through its cycle. No Leaks!!! Be sure to unplug before doing any repair work; if you don't you may not like the outcome.