Do-It-Yourself Story

1.) Water Leaking from Pump Motor and Motor Assembly/Housing; Suspected old O-Ring & Separation of Motor and Assembly. Replaced Pump and Motor Assembly, because the motor over time separated from the housing and was slowly leaking onto the floor. This replacement resolved the issue and wasn't too difficult. I did have to have my wife help install the 3 plastic holders (from underside) while I held the unit in place from the inside. Everything went very smooth and no leaks now. Tools: Philips Screw Driver and Pliers used for this repair. Repair video was spot on. Special Note: I would suggest putting a blanket or towel down with hardwood floor so no scratches and also to help collect any water from assembly or drain hose when removed. 2.) Water Leaking from Float Body. Small Leak from the float assembly that would drip when the float arm would go up and down. It appears the gasket over time thinned up from heat cycles and was a lot flatter than the new gasket. The new gasket created a much better seal. Everything went very smooth and no leaks now. Tool: Pliers for this repair.