Ordered a new motor from Appliancepartspros.com. It took about 45 minutes to install. I removed the old motor and took the fan blade off to let soak in warm soapy water while I spliced the old wire connector to the new motor. I made the new wire connection from the motor that same length as before so I would not have to tape up any excess wires.Then I vacuumed around the condenser and fan area, cleaned the blade and installed the new motor.
I used the fan blade nut supplied with the new motor but found that the mounting screws supplied were a different size than the 5/16" bolts that held the old motor. I just reused the old mounting bolts. Be sure to mount you motor so that the wire connectors are at the same point as before or they may not reach your connection. I tested the fan before putting the back panel on the frig and the motor ran smooth and quite. Very pleased with this repair and part.