Parts for Frigidaire FEB24S5ASD: 07 - Door Parts

This replacement glass panel restores the viewing window and heat barrier in your oven door. Swap a damaged pane to maintain safe operation, proper heat retention, and a clean, clear view of what's cooking.

• Provides the door's viewing window and helps insulate the oven cavity
• Restores visibility into the oven during baking and broiling
• Replace if the glass is cracked, shattered, scratched, or permanently stained
• Common symptoms include visible damage, heat loss, uneven baking, or exterior door area feeling hotter than normal

What's included: 1 glass panel Install notes:

• Disconnect power (and shut off gas, if applicable) and allow the appliance to cool completely
• Wear cut-resistant gloves and eye protection; tape over broken glass before removal
• Note pane orientation, spacers, and seals; transfer any hardware in the same positions
• Avoid overtightening fasteners and clean fingerprints from the new glass after installation

This inner oven door liner replaces the damaged or worn interior panel that surrounds the oven cavity, restoring the door's sealed inner surface and helping maintain proper cooking conditions and easy cleanup. What it does:

• Forms the inner surface of the oven door and protects insulation and outer door components
• Helps maintain oven heat containment for consistent cooking performance
• Provides a smooth, cleanable interior surface to prevent food buildup
• Restores fit and finish when the original liner is cracked, dented, or warped

• One oven door inner liner

• Requires removal of the oven door and disassembly of the door panels; follow the oven manufacturer's door-removal instructions
• Handle carefully to avoid scratching the finished surface and to protect any attached glass or trim
• Disconnect power to the appliance before beginning work to avoid electrical or heating-element hazards

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts

This adhesive seal tape is a replacement sealing strip used to restore a tight seal on appliance doors and panels, helping reduce air leaks and improve temperature control. It's a simple repair for worn or damaged seal edges. What it does:

• Provides a flexible, adhesive sealing surface to close gaps between door/panel and cabinet
• Helps reduce air or moisture leakage that can cause temperature loss or inefficient operation
• Restores worn or deteriorated sealing surfaces without replacing the entire gasket
• Compatible with applications where a narrow adhesive sealing strip is required

• Clean and dry the mounting surface thoroughly before applying for best adhesion
• Measure and trim the tape to fit; press firmly along the full length to ensure contact
• Allow adhesive to set per ambient conditions before closing the door or returning to service