Parts for Ge FUF14DTDRWH: 01 - Door Parts

This inner door panel replaces a damaged or worn freezer interior surface to restore proper bin mounting and appearance. It provides the structural backing for door shelves and helps maintain a tight interior arrangement. What it does:

• Replaces cracked, warped, or dented inner freezer door surfaces
• Restores secure mounting points for door bins and shelves
• Helps keep interior components aligned and prevents rubbing or interference
• Improves cosmetic appearance of the freezer door interior

• Disconnect power to the appliance before starting any repair.
• Remove the door liner carefully; clips or screws may secure the panel—retain all fasteners.
• Inspect and reuse door bins, seals, and mounting hardware as required; replace damaged clips.

This replacement freezer door gasket restores a tight seal to help keep the freezer cold and reduce frost buildup. Designed to fit the freezer door, it gives an easy, low-cost way to improve cooling performance and efficiency. What it does:

• Seals the freezer door to prevent warm air and moisture from entering
• Helps reduce frost buildup and maintains consistent internal temperature
• Restores proper door closure when the existing gasket is cracked, flattened, or torn
• Supports energy efficiency by minimizing cold-air loss

• Inspect door frame and mounting channel; clean and dry before installing the new gasket
• Press gasket into the door channel evenly, starting at one corner and working around the perimeter
• For best seal, level and align the door after installation; allow gasket to seat for several hours
• Disconnect power only if needed for light removal tasks

This is one (1) piece. Some models will require multiples of this part.

This replacement door stop cushions and limits refrigerator door travel to protect the hinge and door edge while helping the door close smoothly and quietly. Fits where the stop mounts at the hinge or cabinet edge to control door movement. What it does:

• Acts as a cushion between the door and cabinet/frame to reduce impact and noise
• Limits door travel to prevent over-rotation that can damage hinges or seals
• Helps restore a door that slips, slams, or doesn't close smoothly
• Simple, passive part that prevents wear at the hinge mounting point

• One replacement door stop

• High-level; basic hand tools may be required. Follow appliance-specific service instructions.
• Power off and unplug the appliance or disable power to the area if working near electrical components.
• Remove the door or access hinge per the appliance manual if needed to reach the stop; align and secure the new stop in the original location.
• Inspect hinge screws and surrounding fasteners; replace or tighten as needed to ensure proper door alignment.

A small retention clip designed to hold appliance trim, panels or components securely in place to prevent movement and vibration. Fits where a compact spring-style clip is required for reliable fastening. What it does:

• Secures trim, panels or small assemblies to a mounting channel or frame
• Holds parts under light tension to prevent rattling or misalignment
• Restores proper fit where a worn or broken clip allows gaps or movement
• Used in areas that require a low-profile spring retention solution

• One clip spring

• Disconnect power and/or water supply before working on the appliance
• Remove surrounding trim or panels carefully to avoid damage
• Use pliers or a trim tool to compress and seat the clip; wear eye protection and gloves
• Replace only with the correct part number to ensure proper fit and retention