Parts for Ge FUF17DHRBWW: Door Parts

This replacement freezer door gasket creates a tight seal around the freezer door to help keep cold air in and reduce frost and energy loss. Fits factory channel-style mounting for a clean, finished appearance. What it does

• Seals the gap between the freezer door and cabinet to maintain proper internal temperature
• Helps reduce frost buildup and prevents warm air infiltration
• Restores door alignment and improves cooling efficiency when the old gasket is worn or damaged
• Commonly replaced when you see visible cracks, tears, deformation, or persistent leaking of cold air

• One freezer door gasket (white) as shown

• Disconnect power to the appliance before starting any repair
• Remove the old gasket and thoroughly clean the gasket channel before installing the new gasket
• Press the gasket into the channel, ensuring the sealing bulb seats fully around the door perimeter; some softening with warm water or a hairdryer can help with fit
• Inspect the seal and door alignment after installation; if gaps remain, re-seat or adjust as needed

A small retention clip designed to hold appliance trim, panels or components securely in place to prevent movement and vibration. Fits where a compact spring-style clip is required for reliable fastening. What it does:

• Secures trim, panels or small assemblies to a mounting channel or frame
• Holds parts under light tension to prevent rattling or misalignment
• Restores proper fit where a worn or broken clip allows gaps or movement
• Used in areas that require a low-profile spring retention solution

• One clip spring

• Disconnect power and/or water supply before working on the appliance
• Remove surrounding trim or panels carefully to avoid damage
• Use pliers or a trim tool to compress and seat the clip; wear eye protection and gloves
• Replace only with the correct part number to ensure proper fit and retention

This inner door panel for the freezer restores the interior liner of a refrigerator freezer door, providing a clean finished surface and support for door shelves and components. It replaces a cracked, warped, or damaged door liner to help the door close and function as intended. What it does:

• Replaces the freezer door's interior liner and provides mounting surface for internal components and shelves
• Restores structural support where cracks, dents, or impact damage occur
• Helps maintain proper door fit when tabs and mounting points are intact
• Addresses visible damage, holes, or interior surface separation

• Disconnect power before servicing and remove stored food from the door area
• Handle the panel carefully to avoid cracking plastic tabs or scratching the finish
• Replacement typically requires removing door shelves and fasteners; retain all screws and trim for reinstallation
• If mounting clips or seals are damaged, replace them separately.

A metal replacement refrigerator door handle that restores a secure grip and original appearance. Fits select GE refrigerators and replaces a broken, bent or worn door handle for reliable daily use. What it does:

• Provides a sturdy, metal grip for opening and closing the refrigerator door
• Replaces cracked, bent or loose handles that affect door operation or appearance
• Helps restore proper handle alignment and a finished look to the door
• Matches factory fit and mounting locations for a straightforward replacement

• Support the door while removing/installing the handle to avoid strain on hinges
• Use correct tools for fasteners and avoid over-tightening to prevent damage
• Follow all manufacturer safety instructions; disconnect power only if working near electrical components