Parts for Lg LMV2083SW/00: Door Parts

This truss head tapping screw secures panels, brackets, and covers in your appliance. Replacing a missing or damaged fastener restores a snug fit, reduces vibration, and helps keep components properly aligned for reliable performance.

• Provides low-profile holding power; wide truss head helps secure thin panels and trim
• Replaces lost, stripped, or corroded screws at the original mounting points
• Helps eliminate rattling, vibration, or loose handles/covers
• Addresses situations where a screw will not tighten or backs out during use

• Disconnect power; shut off water/gas if applicable before servicing
• Align parts and hand-start threads to avoid cross-threading
• Tighten until snug; do not overtighten to prevent stripping
• If the receiving hole is damaged, for repair before installing the new screw

This door frame assembly replaces a damaged or cracked outer door frame to restore the washer/dryer door's appearance and structural support. It helps secure the door glass and maintain proper door alignment for safe operation. What it does:

• Replaces a broken, cracked, or warped outer door frame to restore form and function
• Supports and secures the door glass/window to prevent rattling or movement
• Helps maintain correct door alignment so the latch and seal engage properly
• Can reduce drafts, leaks, and vibration caused by a damaged frame

• Disconnect power (and water if applicable) before starting any repair
• Handle glass and frame edges carefully; wear gloves and eye protection
• Retain original screws and mounting hardware unless replacement parts are supplied
• Check door seal/gasket and latch engagement when reinstalling to ensure a proper fit

Replacement door handle that restores a secure, comfortable grip and original appearance to your refrigerator door. Matches the factory fit and finish for a straightforward swap without replacing the full door. What it does:

• Provides a sturdy, ergonomic grip for opening and closing the refrigerator door
• Replaces cracked, loose, broken, or cosmetically damaged handles
• Restores the original look and helps maintain normal door operation
• Intended to use with the refrigerator's factory mounting locations and fasteners

• Use basic hand tools; remove any trim or access panels to reach the handle fasteners
• Support the door while removing/installing the handle to avoid damage or misalignment
• Retain and reuse original screws/fasteners unless new hardware is explicitly supplied
• Refer to your model's service manual for step-by-step instructions and follow all safety precautions