Parts for Maytag AMV6502REW0: 03 - Door Parts

A white replacement door handle that restores a usable grip and appearance to your appliance door. Ideal when the original handle is cracked, loose, or missing so the door can be opened and closed reliably. What it does:

• Provides a secure grip for opening and closing the appliance door.
• Replaces cracked, broken, loose or missing handles that make the door difficult to operate.
• Matches original mounting points for a direct-fit replacement.
• Restores the door's finished appearance and basic function.

• Disconnect power (and water, if applicable) before beginning any repair.
• Access the handle mounting screws by opening/removing the door panel per the OEM service instructions.
• Use basic hand tools and retain all original fasteners and trim for reassembly.

This genuine replacement door handle restores a secure grip and smooth operation to your appliance door. It replaces a worn, cracked, or broken handle so you can open and close the door safely and comfortably. What it does:

• Provides a sturdy handhold for opening and closing the appliance door
• Replaces cracked, loose, or broken handles that cause difficulty operating the door
• Restores proper alignment and fit where the original handle has worn or failed
• Helps reduce accidental slippage or dropping of the door during use

• One door handle

• Handle requires basic hand tools for removal and installation; refer to your model's service instructions
• Keep the appliance unplugged or power disconnected when working near electrical components
• Tighten mounting fasteners securely but avoid over-torquing to prevent cracking
• If the handle mounts to an inner door panel or trim, support the door edge to avoid damage during installation

Color: White

Color: Black

Color: White

Color: Black

This door latch is the replacement latching mechanism that secures the appliance door during operation, restoring proper door closure and safe operation. It fits the factory mounting and engages/disengages the door as designed. What it does:

• Secures the door closed so the appliance can run and maintain temperature or cycle safety systems
• Replaces a broken, worn, or loose latch that won't hold the door shut
• Commonly used when the door won't stay closed, won't latch, or the appliance won't start because the door is not detected as closed
• Engages with the door strike to ensure a positive, spring-loaded closure

• One door latch

• Disconnect power (unplug or switch off breaker) before beginning any repair
• Access may require removing the oven/dryer front panel or door trim
• Align the latch with the mounting holes and secure with the original screws; test latch operation before fully reassembling
• If electrical connectors are present, ensure they are fully seated and undamaged

This handle base secures the exterior handle to the appliance door or drawer and covers the mounting point. Replacing a cracked or stripped base restores a solid, aligned handle and a clean, finished look.

• Anchors the handle to the door/drawer and provides a stable mounting point
• Helps keep the handle straight and tight during use
• Covers mounting hardware for a finished appearance
• Addresses issues like a loose or wobbly handle, broken/missing base, or stripped mounting threads

• Disconnect power to the appliance before servicing
• Remove the handle by loosening set screw(s) or mounting screws, then remove the old base
• Position and fasten the new base; transfer/reuse existing screws if applicable
• Reinstall the handle and tighten securely without overtightening; verify alignment and operation