Parts for Maytag YAMV2307PFS0: 03 - Door Parts

This outer microwave door assembly restores the appliance's sealed cooking cavity and user access, helping stop steam and food splatter while allowing the door to latch and the microwave to operate safely. Fits as a direct replacement for the original door assembly. What it does:

• Replaces a cracked, warped or damaged outer microwave door that won't close or latch properly
• Restores the door seal and alignment to help contain heat and cooking vapors
• Allows door switches and latch mechanisms to engage so the oven will run
• Improves appearance when the original door is dented, scratched, or cosmetically worn

• Disconnect power before servicing to avoid electrical shock; this part requires removing the microwave door and/or front trim.
• Handle glass and metal edges carefully; wear gloves and eye protection.
• Keep internal door components and wiring intact unless replacing them explicitly; follow OEM disassembly/reassembly steps.
• If door switches or latch components are damaged, inspect and replace those parts separately as needed.

Replace a damaged or non-sealing microwave outer door to restore safe cooking and proper door closure. This outer door assembly provides the exterior panel, latch area and viewing window needed for secure operation and heat containment. What it does:

• Replaces a cracked, dented or warped outer door panel so the microwave closes and seals correctly
• Restores the door latch area to help the unit start and run normally
• Replaces a door with a damaged viewing window or cosmetic defects
• Helps address issues like the door not closing fully, visible damage, or difficulty latching

• One outer microwave door assembly

• Disconnect power and ensure the unit is fully de-energized before starting
• Handle glass and trim carefully; support the door during removal and installation to avoid damage
• Verify latch engagement and door alignment after installation; adjust hinges per the service manual if needed
• Inspect for proper operation; replace switches only if faulty