Parts for Lg LRE3012ST/00: Drawer Parts

This factory-specified fastener secures designated panels and components, restoring a precise fit and helping keep your appliance solid and quiet. Replace a missing, stripped, or rusted original with the correct OEM match for the specified locations.

• Secures brackets, panels, and internal parts where this part number is called out
• Replaces damaged, stripped, corroded, or lost screws
• Helps reduce looseness and vibration that can cause rattling noises
• Exact OEM replacement for positions requiring this specific screw

• Disconnect power and shut off water/gas before servicing
• Match to the removed screw and install only in the locations specified for this part number
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening, especially into plastic
• If multiple screws are involved, start all fasteners before final tightening to ensure alignment

This replacement door frame restores the exterior trim around the appliance door for a finished appearance and proper panel alignment. It helps seal and support the door while keeping the control area and window secure. What it does:

• Replaces damaged, cracked, or warped door trim that can cause gaps or misalignment
• Restores proper fit between the door and cabinet to help reduce drafts and vibration
• Supports the door glass/window and outer panel for safe, consistent operation
• Improves appearance by covering chips, dents, or cosmetic wear

• One door frame

• Designed for direct replacement; part number matches your appliance before ordering
• Remove power and follow the manufacturer's service manual for disassembly to avoid damage
• Handle glass and trim edges carefully; wear gloves and eye protection
• If clips or screws are missing or damaged, replace them with OEM fasteners for secure fit

This foot is a small rubber base pad that supports and stabilizes the appliance on the countertop or cabinet surface. Replacing a worn or missing foot helps keep the unit level and reduces vibration and slipping.

• Provides stable, non-slip support on flat surfaces
• Helps keep the appliance level for proper operation
• Replaces missing, cracked, or flattened feet
• Can reduce vibration, rattling, or shifting during use

• Unplug the appliance before servicing
• Turn the unit on its side/back for access to the base
• Pull off the old foot and press the new one firmly into place (some models may use adhesive or a tab fit)
• Verify the unit sits level; replace additional feet as needed

This idler bracket mounts the idler pulley or roller in your appliance's tensioning system, keeping a belt or cable aligned and properly tensioned for consistent operation. A bent or worn bracket can cause noise, slippage, or loss of motion.

• Secures the idler pulley/roller in the correct position
• Maintains proper belt/cable tension and alignment
• Helps reduce squealing or squeaking from friction/misalignment
• Can address belts/cables coming off or intermittent movement in the drive mechanism

• Disconnect power; also shut off gas or water before servicing
• Access the tensioner area and note the belt/cable routing and spring orientation
• Relieve tension, remove the old bracket, and transfer the pulley/roller and any spring or hardware as required
• Reinstall the bracket, ensure smooth free movement, route belt/cable correctly, and test operation

This guide rail is the drawer slide that supports and guides a refrigerator or freezer drawer for smooth, stable opening and closing. It restores proper drawer alignment and prevents sticking or sagging for easier access. What it does:

• Supports and guides the drawer along its track for consistent movement
• Keeps the drawer aligned to prevent binding, wobbling, or uneven closing
• Reduces noise and catching during opening and closing
• Helps prevent the drawer from falling out or becoming detached when pulled

• Remove food and drawers before replacing the rail to avoid damage or injury
• Use appropriate hand tools; avoid forcing parts to prevent breakage
• Disconnect power to the appliance if panel removal requires access to electrical components