Parts for Lg LRG4113ST: Drawer Parts

This idler bracket secures the idler in the drive system, keeping the belt aligned and properly tensioned for smooth operation. Replacing a bent or worn bracket helps reduce noise and restore consistent belt tracking.

• Holds the idler in position to maintain proper belt tension and alignment
• Helps prevent belt slippage, squealing, or scraping noises
• A bent, cracked, or loose bracket can cause the belt to come off or loss of drive motion
• Visible wear or misalignment around the idler mount is a common replacement indicator

• Disconnect electrical power; if applicable, shut off gas supply before servicing
• Access the drive system and relieve belt tension before removal
• Transfer the idler pulley and spring (if applicable) to the new bracket
• Reinstall in the original orientation and verify correct belt routing and alignment before test run

This outer door frame secures and finishes the refrigerator/freezer door, restoring proper fit and appearance. Replaces a damaged, cracked, or warped frame to help the door seal and close correctly. What it does:

• Provides the structural trim around the door opening and anchors the door panel
• Restores proper alignment and improves door closure when the frame is warped or broken
• Prevents drafts by supporting the door gasket area
• Helps eliminate rattling or loose front panels caused by a damaged frame

• 1 outer door frame

• Disconnect power to the appliance before starting any repairs
• Remove door trim screws and panels carefully to avoid damaging the door or gasket
• Handle the frame and surrounding trim gently to prevent cracking; some clips may be brittle with age

This front plate is the outer panel that restores the appliance's exterior appearance and provides a finished surface for controls and openings. It replaces damaged, dented, or scratched front panels to improve looks and panel alignment. What it does:

• Replaces a cracked, dented, or warped front panel that affects appearance
• Restores proper fit and alignment of control openings and trim
• Helps protect internal components from light bumps and cosmetics damage
• Returns the appliance to a uniform, factory-style exterior

• One front plate

• High-level swap: remove power, detach surrounding trim or control assembly, replace panel, and reassemble; follow manufacturer disassembly order
• Disconnect power before starting. Wear gloves to avoid sharp edges.
• Use manufacturer screws and retainers. Do not force panels; check alignment before tightening.
• If fastening points or clips are damaged, replace them with OEM-specified hardware.

This replacement slider restores smooth, guided movement for the appliance component it mounts to, helping reduce sticking, binding and noise. A simple, low-cost part that returns parts to proper alignment and operation. What it does:

• Guides and supports a moving panel or drawer to ensure even, low-friction travel
• Reduces binding, catching or noisy movement when the original slider is worn or damaged
• Keeps the associated component aligned to prevent uneven wear or mis-tracking
• Helps restore normal operation without replacing larger assemblies

• One replacement slider

• Disconnect power to the appliance before beginning any repair
• Remove the affected panel/drawer per the appliance service instructions to access the slider
• Inspect surrounding tracks or mounting tabs for damage and replace if necessary
• Test movement after installation; if binding persists, re-check alignment

This slider is a replacement glide piece that helps a drawer or sliding compartment move smoothly and stay aligned. Replacing a worn slider restores quiet, consistent travel and prevents wear on the surrounding trim. What it does:

• Guides and supports a drawer or sliding compartment for even movement
• Reduces sticking, scraping, and noisy operation from worn glides
• Keeps the drawer aligned to prevent rubbing or binding against the cabinet
• Helps extend life of associated rails and trim by restoring proper tracking

• One slider glide piece

• Disconnect power to the appliance and remove any contents before servicing
• Remove the drawer or access panel per your appliance instructions to reach the slider
• Inspect mating rail and fasteners; replace any damaged clips or screws for a secure fit