Parts for Frigidaire F45WP26CW2: 02 - Freezer Door Parts

Refrigerator freezer door gasket seals cold air inside. Replace if worn, torn, or allowing air leaks. Confirm fit with your model number before ordering.

Replacement end cap support for refrigerator door racks. Secures and stabilizes door bins. Needed when original support is cracked, broken, or missing.

Endcap support bar for refrigerator door racks. Secures and stabilizes door bins. Replace if cracked, broken, or missing to restore proper door storage.

Cut to fit design.

Refrigerator door bar with end caps installs on the inner door to hold bottles and condiments. Replace if cracked, broken, or missing end caps.

Mounting screw for refrigerator interior components and panels. Replace if stripped, missing, or corroded to secure parts properly and maintain alignment.

Phillips truss head screw secures the door stop assembly on your refrigerator. Replace if missing, stripped, or damaged during door maintenance or repair.

Mounting screw for grass line trimmers. Secures components to housing or frame. Replace if stripped, corroded, or missing for proper assembly.

Nylon mounting nut secures components in your refrigerator. Replace if cracked, stripped, or loose to restore proper fastening. Verify fit by model.

Replacement screw for various appliances. Used to secure panels, components, or housing. Replace if stripped, corroded, missing, or damaged hardware.

This connector door harness links the cabinet wiring to the refrigerator door, restoring electrical connections for door-mounted components. Use this harness to replace a damaged or corroded door connector and regain reliable electrical contact. What it does:

• Provides the sealed electrical connection between the cabinet wiring and the door harness
• Restores power and signal to door-mounted parts such as switches, lights, and dispenser controls when the original connector fails
• Prevents intermittent or lost connections caused by worn, damaged, or corroded terminals
• Maintains proper connector alignment and strain relief for the door wiring

• One connector door harness

• Always disconnect power to the appliance before beginning any repair
• Installation typically requires removing the door panel or inner liner to access the connector
• Inspect mating terminals and wiring for damage; replace or repair any frayed wires before reconnecting
• Ensure connectors are fully seated and secured; test door functions after reassembly

Note: This is a 1/4" x 1/4" compression elbow fitting without the nuts. See part# 4932JA3009A which is a 1/4" by 1/4" John Guess quick connector elbow. 

#10 OD, steel

Size: Approximate 2.5 inches thick, 33 inches wide and 70 inches long.