Parts for Frigidaire FRS22WNCD2: 02 - Freezer Door Parts

Replacement end cap support for refrigerator door racks. Secures and stabilizes door bins. Needed when original support is cracked, broken, or missing.

Endcap support bar for refrigerator door racks. Secures and stabilizes door bins. Replace if cracked, broken, or missing to restore proper door storage.

Refrigerator door rack installs on the interior door to hold condiments and beverages. Replace if cracked, broken, or missing. Includes endcaps.

Cut to fit design.

Phillips truss head screw secures the door stop assembly on your refrigerator. Replace if missing, stripped, or damaged during door maintenance or repair.

Secures refrigerator door handle to door panel. Replace if screw is stripped, corroded, missing, or if handle has become loose or wobbly over time.

Mounting screw for grass line trimmers. Secures components to housing or frame. Replace if stripped, corroded, or missing for proper assembly.

Exterior trim piece that covers and finishes the door handle area. Replace when the original trim is cracked, loose, or missing to restore appearance.

Nylon mounting nut secures components in your refrigerator. Replace if cracked, stripped, or loose to restore proper fastening. Verify fit by model.

Replacement screw that secures brackets, shelves, trim, panels, and covers inside your appliance. Install when the original is missing, stripped, or corroded.

This connector door harness links the cabinet wiring to the refrigerator door, restoring electrical connections for door-mounted components. Use this harness to replace a damaged or corroded door connector and regain reliable electrical contact. What it does:

• Provides the sealed electrical connection between the cabinet wiring and the door harness
• Restores power and signal to door-mounted parts such as switches, lights, and dispenser controls when the original connector fails
• Prevents intermittent or lost connections caused by worn, damaged, or corroded terminals
• Maintains proper connector alignment and strain relief for the door wiring

• One connector door harness

• Always disconnect power to the appliance before beginning any repair
• Installation typically requires removing the door panel or inner liner to access the connector
• Inspect mating terminals and wiring for damage; replace or repair any frayed wires before reconnecting
• Ensure connectors are fully seated and secured; test door functions after reassembly

Note: This is a 1/4" x 1/4" compression elbow fitting without the nuts. See part# 4932JA3009A which is a 1/4" by 1/4" John Guess quick connector elbow. 

#10 OD, steel

Size: Approximate 2.5 inches thick, 33 inches wide and 70 inches long.