Parts for Ge FUF14DVDRWW: 01 - Freezer Door Parts

This inner door panel replaces a damaged or worn freezer interior surface to restore proper bin mounting and appearance. It provides the structural backing for door shelves and helps maintain a tight interior arrangement. What it does:

• Replaces cracked, warped, or dented inner freezer door surfaces
• Restores secure mounting points for door bins and shelves
• Helps keep interior components aligned and prevents rubbing or interference
• Improves cosmetic appearance of the freezer door interior

• Disconnect power to the appliance before starting any repair.
• Remove the door liner carefully; clips or screws may secure the panel—retain all fasteners.
• Inspect and reuse door bins, seals, and mounting hardware as required; replace damaged clips.

This replacement freezer door gasket restores a tight seal to help keep the freezer cold and reduce frost buildup. Designed to fit the freezer door, it gives an easy, low-cost way to improve cooling performance and efficiency. What it does:

• Seals the freezer door to prevent warm air and moisture from entering
• Helps reduce frost buildup and maintains consistent internal temperature
• Restores proper door closure when the existing gasket is cracked, flattened, or torn
• Supports energy efficiency by minimizing cold-air loss

• Inspect door frame and mounting channel; clean and dry before installing the new gasket
• Press gasket into the door channel evenly, starting at one corner and working around the perimeter
• For best seal, level and align the door after installation; allow gasket to seat for several hours
• Disconnect power only if needed for light removal tasks

This is one (1) piece. Some models will require multiples of this part.

A small retention clip designed to hold appliance trim, panels or components securely in place to prevent movement and vibration. Fits where a compact spring-style clip is required for reliable fastening. What it does:

• Secures trim, panels or small assemblies to a mounting channel or frame
• Holds parts under light tension to prevent rattling or misalignment
• Restores proper fit where a worn or broken clip allows gaps or movement
• Used in areas that require a low-profile spring retention solution

• One clip spring

• Disconnect power and/or water supply before working on the appliance
• Remove surrounding trim or panels carefully to avoid damage
• Use pliers or a trim tool to compress and seat the clip; wear eye protection and gloves
• Replace only with the correct part number to ensure proper fit and retention

This shoulder screw secures components while creating a precise spacer point for proper alignment and movement. Durable hardware replacement for assemblies that rely on a fixed shoulder to control travel and spacing. What it does:

• Acts as a fastener and built-in spacer to position components accurately
• Provides a smooth, cylindrical shoulder for moving parts to bear against
• Prevents over-insertion of screws and helps maintain alignment of panels or linkages
• Common symptom: missing, stripped, or damaged shoulder screw can cause loose parts, misalignment, or rattling

• Disconnect power and follow appliance safety procedures before servicing
• Use the correct driver and avoid overtightening to protect threads and shoulder
• Keep small parts secure during installation to prevent loss or damage

This EZ-Set electronic temperature control board coordinates the refrigerator's cooling and defrost functions by processing thermistor inputs and user settings. When it fails, temperatures can drift or controls may be unresponsive; replacing the board restores consistent operation.

• Interprets thermistor signals to regulate cooling cycles
• Manages automatic defrost timing to help prevent frost buildup
• Responds to EZ-Set temperature adjustments from the user interface
• Common symptoms include: too warm or too cold temperatures, runs constantly or will not run, excessive frost, unresponsive/erratic controls

• Disconnect power before servicing; observe ESD precautions and handle the board by its edges
• Take photos of wiring and move connectors one at a time to the new board
• Ensure all connectors are fully seated and routed away from moving parts
• Restore power and allow up to 24 hours for temperatures to stabilize;