Parts for Ge ZISS420NKCSS: Freezer Door Parts

The water filter is an OEM part for GE refrigerators. This filter removes or reduces various contaminants.

Features and Benefits:

• Easy DIY replacement, typically mounted inside the refrigerator at the back of the compartment.
• Removes or reduces various contaminants in your water and ice, including lead, cysts, asbestos, atrazine, , taste and odor, chlorine, sediment, turbidity, and more
• NSF/ANSI 42 and 53 standards
• 6 Month lifespan filter
• Carbon Block media
• Micron rating: 0.5-1 micron (Class I)

When to replace your filter:

• Bad taste or odor in water and ice
• Cloudy or discolored ice
• Reduced water flow or pressure
• Refrigerator replace filter indicator light is on

Note: If replacing the Culligan metal canister design filter for the first time, a special adapter, part number AP2615702 is needed, which is not included with this part. The compatible bypass cap is part number AP6891551.

This OEM GE part can also be used on Hotpoint, RCA, and Kenmore/Sears appliances. 
 

This replacement freezer bottom hinge bushing helps the freezer door pivot smoothly and maintain proper alignment, reducing rubbing and uneven wear for more reliable closing. What it does:

• Provides a smooth pivot surface for the freezer bottom hinge
• Restores proper door alignment to help ensure a tight seal
• Reduces hinge noise, sticking, and rubbing during door movement
• Helps prevent premature wear of the hinge and door components

• One freezer bottom hinge bushing

• Disconnect power to the appliance and empty or support the door before starting
• Support the door while removing hinge fasteners to prevent falling or injury
• Inspect the hinge and shaft for wear; replace the hinge assembly if damaged
• Do not overtighten fasteners; test door operation after installation

This gasket and label assembly replaces a worn or damaged side-by-side refrigerator door seal and its attached label, restoring a proper seal to help maintain consistent cooling and reduce frost buildup. Fits the refrigerator door where original gasket is mounted. What it does:

• Seals the door perimeter to help keep cold air inside and warm air out.
• Helps reduce frost or ice buildup caused by a leaking or damaged seal.
• Addresses symptoms such as visible gaps around the door, excessive frost, or uneven temperatures inside the compartment.
• Includes the attached product/identification label as shipped from the manufacturer.

• Unplug the appliance before starting any work and remove food and door-mounted items.
• Replace the old gasket by loosening any retainer or screws, positioning the new gasket into the retainer, and securing per the service manual; do not force or stretch the gasket.
• After installation, check the door seal around the full perimeter and adjust the door alignment if needed; follow the manufacturer's service instructions for final seating.
• If retainers, clips, or screws are damaged or missing, order those parts separately.

Restore secure, organized door storage with this door bin assembly. It replaces a cracked or missing bin so bottles, jars, and condiments stay in place, easy to reach, and less likely to tip or spill.

• Creates a sturdy shelf on the door to hold jars, bottles, and condiments
• Common symptoms: cracked plastic, broken/loose mounting tabs, bin falls off or won't stay seated, missing bin
• Restores original door storage capacity and organization
• "36/42" denotes the manufacturer's designated bin style for those series; confirm fit by model

• Remove items from the old bin; lift the bin straight up to release from the door rails
• Allow cold plastic to warm to room temperature before handling to reduce cracking risk
• Align new bin on the molded door ribs/rails and press down until fully seated
• Verify a secure fit before reloading; avoid overloading the bin