Parts for Ge FCM11PHBWW: Freezer Parts

Replace your freezer door seal if you notice frost buildup, warm spots, or higher energy bills. Ensures airtight closure for optimal temperature. Verify fit with your model number.

Protects the tub opening and prevents fabric snags at the basket edge. Replace if cracked, worn, or missing to maintain a proper seal. Verify fit with your model.

Replacement hanging basket for freestanding freezers. Installs inside freezer compartment for organized storage. Order when original is cracked or broken.

Fix water pooling under your freezer with this drain tube cover. Directs defrost water into the drain system to prevent leaks. Simple DIY repair.

If your freezer won't maintain temperature or runs constantly, a faulty thermostat is often the culprit. This direct-fit part regulates internal temps.

Control panel for freezers not responding to temperature adjustments or displaying error codes. Direct replacement part restores full function.

Replace your freezer's LED lamp when interior lighting fails or dims. Directly installs into lamp housing. Confirm fit with your model number.

Overload protector for freestanding freezers. Protects the compressor from electrical overload. Replace if cracked, damaged, or missing.

Fix a freezer that won't start or has a compressor that won't run. This starter relay engages the compressor circuit. DIY-friendly repair in under 30 minutes.

This rubber grommet cushions and protects components where a snug, vibration-resistant fit is needed. It helps keep panels, wires or small parts seated and prevents chafing or rattling for quieter, safer operation. What it does:

• Provides a soft, vibration-damping mount to reduce noise from loose panels or components
• Cushions and isolates parts from metal-to-metal contact
• Protects wires and hoses from abrasion where they pass through openings
• Helps hold fittings, clips or small assemblies securely in place

• Disconnect power to the appliance before accessing internal parts.
• Access the panel or opening and remove the old grommet before installing the new one.
• Press the grommet into the hole until fully seated; avoid cutting or stretching it excessively.
• Use caution with sharp tools and fasteners to prevent injury or damage to surrounding components.

This bushing provides a low-friction bearing surface to support and align a rotating shaft or pivot, helping restore smooth, quiet operation and reduce wear on mating parts. What it does:

• Supports and centers a rotating shaft or pivot to maintain proper alignment.
• Reduces friction and wear between moving parts for smoother operation.
• Helps eliminate grinding, binding, or wobbling caused by worn bearings.
• Prevents premature wear of shafts and housings by providing a replaceable wearing surface.

• Disconnect power to the appliance before beginning any repair.
• Inspect surrounding housing and shaft for wear; replace damaged parts as needed.
• Press or tap the bushing into place squarely; avoid deforming the part.
• Ensure correct orientation and full seat for proper function.

Fix freezer defrost issues with a hammer switch replacement. This switch controls defrost cycling in freestanding freezers. Moderate repair difficulty.

Replace your freezer light bulb when it burns out or no longer illuminates the interior. Ensures proper visibility. Confirm fit with your model number.

Replace a broken or missing freezer lock cover that leaves the lock mechanism exposed. Simple snap-on installation takes minutes with no tools required.

Replace a broken or damaged freezer door lock casing that won't secure properly. This housing component ensures your lock mechanism functions correctly.

Replacement push button key for freezer control panels. Restores missing, cracked, or worn buttons so your control panel is functional and easy to use.