Parts for Ge PTG25SBSARSS: 02 - Fresh Food Door Parts

This door gasket seals the freezer compartment to maintain proper temperature and energy efficiency. A direct-fit replacement that helps restore a full door seal and reduce frost build-up when the original gasket is damaged or worn. What it does:

• Creates an airtight seal around the freezer door to help keep cold air in and warm air out
• Helps reduce frost buildup and prevents temperature fluctuation inside the compartment
• Improves cooling performance and can reduce energy loss caused by a leaking seal
• Fits the factory door opening shape to ensure even compression and contact

• One door gasket (black), single-piece as shown

• Remove the old gasket and clean the door channel before installing the new gasket
• Seat gasket evenly around the door; warm with a hair dryer (low) if needed to help form and set the seal
• Check for proper door alignment and full contact after installation; adjust hinges if necessary
• Unplug the appliance or disconnect power before performing any repair

A replacement reversible plug door that covers and protects the appliance power inlet while letting the cord exit left or right for tidy cord routing. Restores a clean back panel appearance and helps keep the power connection protected from debris. What it does:

• Covers the power inlet opening to protect the plug and inlet from dust and debris.
• Reversible design lets you route the power cord to either side to fit against the wall.
• Helps keep the cord tucked close to the appliance so the unit can sit flush with cabinetry or walls.
• Replace when the door is cracked, broken, missing, or no longer holds the plug securely.

• Always unplug the appliance before starting any repair or inspection.
• May require access to the rear panel; check your owner's manual for disassembly steps.
• Check orientation before finalizing installation to ensure correct left/right cord routing.

This module snugger is a small retaining piece used in the refrigerator to hold its associated module or component securely in place. Replacing a cracked or missing snugger restores a tight fit, reduces vibration and noise, and supports correct operation.

• Secures the related module or assembly to prevent shifting
• Helps maintain proper alignment for reliable performance
• Reduces rattles and wear from vibration or movement
• Typical signs it's needed: part is broken or missing, components feel loose, or you hear rattling

• Disconnect power to the refrigerator before servicing
• Note the original orientation and location; take a photo for reference
• Reuse existing fasteners or clips if applicable; avoid overtightening
• After installation, confirm the part holds the assembly firmly and that movement is smooth where intended

This replacement screw fastens refrigerator components securely, restoring a tight, rattle-free fit when original hardware is missing, stripped, or corroded. Use it to secure panels, brackets, or trim and keep parts properly aligned.

• Secures panels, brackets, covers, or trim in place
• Helps maintain correct alignment of components and hardware
• Reduces vibration and rattling caused by loose or missing screws
• Replaces lost, rusted, or stripped screws

• Unplug the refrigerator and turn off water supply if working near water components
• Match thread and length to the removed fastener; hand-start threads to avoid cross-threading
• Tighten snugly; do not overtighten into plastic or thin sheet metal
• Keep track of any spacers or washers reused from the original assembly