Parts for Ge TPS24PIBABS: 02 - Fresh Food Door Parts

This tail handle is the replacement end piece for a refrigerator door handle assembly, restoring a finished grip and proper handle fit. It helps maintain a secure, comfortable hold and keeps the door handle aligned. What it does:

• Replaces a cracked, broken or missing tail/end piece on a refrigerator door handle
• Restores proper fit and finish so the handle sits securely and functions normally
• Helps eliminate looseness, wobble or sharp edges caused by a damaged tail piece
• Matches OEM shape to maintain original handle appearance

• One tail handle piece as shown

• High-level installation: access the door handle ends, remove any retaining screws or clips, swap the damaged tail piece for the replacement, and reassemble
• Use basic hand tools; avoid over-tightening fasteners to prevent cracking
• If the handle is painted or scratched, handle replacement part carefully to avoid surface damage
• Disconnect power only if working near electrical components or lights; otherwise no electrical disconnection is typically required

This is a replacement 8-18 x 9/16 machine screw used to secure internal and external appliance components. It restores proper fastening and helps stop rattling or loose panels caused by worn or missing fasteners. What it does

• Secures panels, brackets, or small assemblies to prevent movement and vibration
• Replaces stripped, corroded, or missing screws that can cause rattling or misalignment
• Helps maintain electrical and mechanical connections by holding parts in proper position
• Appropriate where an 8-18 thread size and 9/16" length are required

• Replacement screw

• Disconnect power to the appliance before accessing internal components
• Use the correct driver to avoid stripping the screw head and ensure proper torque
• Do not overtighten; snug until secure to avoid damaging threads or parts

This is a replacement 10-32 x 1 machine screw used to fasten appliance components. It restores secure mounting of panels, brackets and hardware so parts stay aligned and vibration or rattling is reduced. What it does:

• Secures panels, brackets, housings and small components to the appliance frame
• Keeps control boards, motors or assemblies held firmly in place
• Prevents loose parts that can cause vibration, noise or intermittent connections
• Matches the OEM thread and length for proper fit when replacing a worn or missing screw

• Disconnect power before working inside the appliance
• Use the correct 10-32 driver or bit to avoid stripping the head
• Thread into the original hole and tighten snugly; avoid over-torquing
• Replace with the same size and thread type to ensure proper fit and safety