Parts for Kenmore 363.9631376 (3639631376, 363 9631376): Fresh Food Door Parts

Refrigerator and freezer door bar end cap. Used on both the right and left hand side. Color: white. Measures about 2-1/2 inches high by 3 inches deep.

This push-button plug insulates and seals a control panel push-button, helping keep the button stable and protecting the switch from moisture and debris. Fits where a small plastic button bushing or insulator is needed on the control panel. What it does:

• Provides an insulating bushing for a control panel push-button or switch
• Helps hold the button aligned and reduces wobble or uneven operation
• Shields the switch contacts from moisture and dirt that can cause intermittent operation
• Commonly replaced when the button is loose, damaged, cracked, or missing

• Disconnect power to the appliance before removing the control panel or working near electrical components
• Remove the control panel or trim; use appropriate tools to avoid cracking surrounding plastic
• Install the plug gently; do not force or use excessive heat

The Fresh Food Door Gasket is an OEM part for GE refrigerators. It seals the perimeter of the refrigerator's fresh food door, maintaining the internal temperature by preventing warm air from entering and cold air from escaping. The gasket measures approximately 39-3/4 inches by 29-3/4 inches.

Over time, door gaskets can wear out or become damaged due to constant use, exposure to spills, or mishandling. A faulty gasket compromises the refrigerator's efficiency, leading to increased energy consumption and uneven cooling.

Symptoms of a bad fresh food door gasket include:

• The door not sealing properly
• Increased frost buildup inside the refrigerator
• Warmer than usual refrigerator temperatures
• Higher energy bills due to the refrigerator working harder to maintain cool temperatures

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This dairy door trim is the replacement trim piece for a refrigerator door dairy shelf, restoring a secure shelf edge and finished look. It helps keep the dairy shelf in place and covers the shelf mount for a clean appearance. What it does:

• Replaces cracked, broken, warped, or missing dairy door trim that leaves the shelf edge exposed
• Helps hold the dairy shelf in position and prevents items from catching on a damaged edge
• Restores the door's finished appearance when the factory trim is chipped or discolored
• Fits onto the dairy/door shelf area and interfaces with the existing shelf assembly

• Remove items from the door shelf before beginning; work on a stable surface
• Installation typically requires removing the shelf or existing trim and snapping or sliding the new trim into place
• Use basic hand tools if needed and avoid overtightening fasteners; keep parts and screws for reassembly

This reversible door plug fills the unused mounting hole when you switch the door swing on your refrigerator. It restores a finished appearance and helps keep air and moisture from entering through the opening.

• Covers the unused door hole created during a door swing reversal
• Helps maintain proper sealing and resists drafts/condensation at the opening
• Restores a clean, finished, factory look to the door
• Common symptoms: missing or cracked plug, exposed hole, cosmetic gap on door edge

• Disconnect power before servicing any door components
• Gently pry out the old plug with a plastic trim tool to avoid scratches
• Align the new plug with the opening and press until fully seated and flush
• Verify the door closes properly and the gasket seals evenly

This part is a cut to fit replacement from the manufacturer.