Parts for Frigidaire DGDMFW*2: Frigidaire 27" Dryer - Gas - 5995210126 Frigidaire Electric Dryer Page 6 Parts

Mounting screw for dryer assembly and panel installation. Replace if stripped, missing, or corroded. Essential hardware for secure component attachment.

This part has been discontinued by the manufacturer and is no longer available.

Dryer won't power on or has loose electrical connections? This terminal block mounting screw secures the power connection point. Simple 10-minute fix.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Secures wiring harness to prevent chafing and maintain safe wire routing in washers, dryers, and laundry appliances. Replace if loose or broken. Check your model for compatibility.

This part has been discontinued by the manufacturer and is no longer available.

Replacement timer control knob for dryers. Installs on the control panel to adjust cycle settings. Order this part if your knob is cracked or missing.

Replacement timer mounting screw for dryers. Secures the timer to the control panel. Required when original screw is stripped, missing, or damaged.

A replacement mounting screw used to secure components on compatible Frigidaire appliances. This genuine-style fastener restores proper fit where the original screw is missing, stripped, or damaged for safe operation. What it does:

• Secures trim, panels, brackets, or components to prevent rattling and misalignment
• Restores a proper mechanical connection when the original screw is lost or worn
• Helps eliminate vibration noise caused by loose fasteners
• Compatible with specific Frigidaire assemblies that use this style of screw

• Screw only

• Use the correct screw location and size—do not force or overtighten to avoid stripping threads or cracking plastic parts
• Turn off power or disconnect appliance from power source before accessing internal components
• Wear safety glasses and handle small parts carefully to avoid injury or loss

Dryer not heating or overheating? This resistor regulates temperature control in your dryer's heating system. Simple DIY replacement part.

Dryer buzzer that signals when the drying cycle is complete. Replace if the buzzer sounds weak, distorted, or fails to alert you at cycle end.

Dryer won't power on or has loose electrical connections? This terminal block mounting screw secures the power connection point. Simple 10-minute fix.

Door sagging or panels loose? This #8-32 x 3/8 pan head locking screw secures top brackets and hinges. Quick 5-minute fix with basic screwdriver.

Secures trim pieces and panels to prevent rattling and gaps. Replace when clips break or lose tension, causing loose panels. Verify fit with your model.