Parts for Ge DPVH890GJ2WW: 08 - Gas Valve & Burner Assembly Parts

Package of 12

This small mounting screw secures panels and trim on compatible GE appliances, restoring a solid, vibration-free fit. Use it to replace a missing, stripped, or damaged fastener and keep parts aligned and secure. What it does:

• Fastens panels, trim, or small components to the appliance frame
• Replaces missing or damaged screws that cause loose or rattling parts
• Restores secure attachment when threads are stripped or worn
• Helps maintain proper alignment to prevent noise and component wear

• Use the correct screwdriver size to avoid stripping the head
• Tighten until snug; do not overtighten to prevent thread damage
• Disconnect power or move the appliance to a safe position when accessing internal panels
• Consider a replacement clip or insert as recommended by the manufacturer

This burner assembly is the combustion head for GE gas dryers. It mixes gas and air and directs a stable flame into the heater housing, restoring consistent heat when the original burner is corroded, warped, or clogged.

• Directs the gas flame into the heat chamber for proper drying temperatures
• Works with the igniter, flame sensor, and gas valve to produce heat
• Typical failure symptoms: no heat or intermittent heat, long dry times, burner lights then goes out, unstable/yellow flame
• Physical issues can include rust, warping, or blocked burner ports

• Disconnect power and shut off the gas supply; allow the dryer to cool completely
• Note position of the igniter and flame sensor relative to the burner port; realign during reassembly
• Transfer any reusable fittings from the original burner as needed and verify orifice/fuel type match your installation
• After reconnecting gas, perform a leak check with a non-corrosive soapy water solution before restoring power

This hot surface igniter lights the burner in gas ovens and ranges to enable reliable baking and broiling. It replaces a worn or failing igniter to restore consistent ignition and oven heating. What it does:

• Heats electrically to ignite the oven's gas burner for bake/broil cycles
• Replaces brittle or cracked igniters that cause delayed ignition or no flame
• Helps resolve symptoms like long preheat times, intermittent lighting, or the oven not reaching temperature
• Works as the ignition source only; gas supply and safety systems remain separate

• One hot surface oven igniter

• Disconnect power and shut off gas before servicing; follow appliance safety procedures
• Handle the igniter carefully; the ceramic element is fragile and can break if dropped or twisted
• Inspect and replace mounting screws or terminal connectors if corroded; secure wiring to proper terminals