Parts for Ge GTDS560GF1WS: Gas Valve & Burner Assembly Parts

10-16 x 1/2 mounting screw secures panels, brackets, and internal components in your dryer. Replace when stripped, missing, or corroded for stable assembly.

This silicon controlled rectifier (SCR) controls power flow to heating and motor circuits, restoring proper electronic regulation in appliances that use SCR-based control boards. Replaces a failed SCR to help return normal heat and motor control. What it does:

• Acts as a switch to regulate current to heating elements or motors when the control board signals it.
• Common symptom: unit fails to heat or run when the control board is commanding operation.
• Common symptom: intermittent or no power to specific circuits controlled by the SCR.
• Helps prevent erratic operation when the SCR is functioning properly.

• Disconnect power to the appliance before servicing to avoid shock or injury.
• Handle the SCR carefully; avoid bending the stud or damaging terminals.
• Mount and torque stud to specified appliance hardware; ensure good electrical contact and any required heat sink connection.

Meters gas flow to the dryer burner. Replace if damaged, clogged, or when converting between natural gas and LP. Installs at the burner assembly.

Leak limiter orifice for dryer gas conversion kits. Installs in the burner assembly to regulate gas flow. Replace if damaged, cracked, or missing.

Fix buzzing noises or no flame in your gas dryer with a new valve assembly. Solves igniter glow without ignition. Moderate DIY repair with basic tools.

Mounting screw secures panels and trim on dishwashers. Replace missing, stripped, or damaged fasteners to keep components aligned and vibration-free.

Fix a dryer that won't heat or cycles but doesn't ignite with this gas burner assembly. Restores consistent flame when the original is corroded or clogged.

Gas dryer won't heat? A faulty igniter prevents gas ignition. This hot surface igniter restores heat in about 30 minutes. Direct-fit replacement part.

Secures the gas valve to the dryer chassis. Replace if your mounting bracket is cracked, broken, or missing to restore proper valve alignment and stability.

Fix a dryer that won't heat or igniter glows but burner won't ignite. This dual coil controls gas flow to the burner. 30-45 minute DIY repair.

Hex washer head screw for refrigerators, freezers, and other appliances. Replaces lost, stripped, or damaged screws during repairs or panel assembly.

Fix a dryer that won't heat or cycles on and off when the igniter glows. The gas valve coil controls gas flow to the burner. 30-45 minute DIY repair.