William B Katy , TX November 15, 2019 Appliance: General Electric Dishwasher DDT595SSJ5SS Control board and flood switch Fix went fine, had to pull the dishwasher out to replace flood switch control board was very easy to replace, and fixed the problem. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Adjustable Wrench, Nut Drivers
Muriel P Collinsville , MS May 28, 2022 As nothing worked on my dishwasher. I assumed that the power board needed replacing. I used the video online to take it apart, as it turned out the first part sent, didn’t fit, Appliance Parts Pro took my return, and quickly sent the right part. I am a 79 year old widow, and was able to repair it myself with the online video. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Nut Drivers, Screwdrivers, Wrench Set
Dean H Mesa , AZ August 26, 2025 No lights it would not turn on Replaced the control board on bottom of machine Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Kenny V Pompano Beach , FL January 02, 2022 Appliance: General Electric Dishwasher GDT695SSJ5SS Heating element not working. Heating element not working. Troubleshot using Error and Service Modes. No error codes were returned. Heating element did not heat up during Service Mode. Checked heating element with ohm meter. Continuity and resistance (ohms) was within range (around 16.5 ohms…I didn’t take note of actual reading). Checked voltage during Service Mode at the heating element using a volt meter. Never saw voltage at heating element. Checked Flood Switch with ohm meter. It worked as expected. Ordered and replaced the Control Board. Still no heat. Located the Thermal Cut Out (TCO) on the right underside of the tub about 12 inches from the front of the tub. It was tripped. Pushed the reset button on it and ran Service Mode again. Burnt my finger on the heating element. I was happy about that. :) Dishwasher is working perfectly now. According to all I read. If the TCO trips the Control Board should be replaced. So I don’t feel I replaced the Control Board needlessly. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Pliers, Screwdrivers
Don A Patterson , LA January 09, 2020 Appliance: Model GE DISHWASHER DOES THE SURVEY The dishwasher would start washing, but never complete the cycle. The first board I got was not correct, but appliance parts pros worked with me by sending me a return shipping label and shipping me out the correct board! I received and installed the correct board and the unit is now working as designed! So far I have been very satisfied with appliance parts pros service! Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Pliers, Screwdrivers