General Electric Parts

Second repair after 10 years of service - igniter had cracked and spill overs were causing the others to misfire. This was a two-step process. I took apart the cooktop to see what parts were neded. Screws were all rusted, I had to drill ome out. The burner gaskets broke during the process and needed replacement. One of the burners had deformed due to excess heat. After that initial diagnose, I reassembled the cooktop without the igniters and ordered all the parts I needed. The second stage was... Read more

I contacted Appliance Parts Pros, and told them what the problem was and what it was doing. They sent me an email with the parts number needed to complete the repair. This was a built in a cabinet unit and I required help removing it and reinstalling it. The repair was relative easy once I had the parts and it took approximately four hours,. It took longer getting to the defective parts than replacing them. ... Read more

Replaced heating element. Read more

In the How to fix it your self section of Questions and Answers, your answers for removing the Base Spray Arm is incorrect. It states "just stick a screw driver into the base spray arm from inside the tub and turn", that does not work. Their are 2 tabs that in gauge the base spray arm with the tub. A 4 prong round wrench is required to insert from the bottom into the pump connector and turn the nut that sits inside. Read more