Parts for GC36: Hob Top Parts

This cast burner spreader fits the wok burner assembly and helps direct gas flames for even heat under wok-style cookware. Replaces a damaged or warped spreader to restore stable, concentrated heating for high-heat cooking. What it does:

• Directs and shapes burner flames for wok cooking and high-heat searing
• Helps maintain an even flame pattern across the wok bottom
• Replaces cracked, warped, or corroded spreaders that cause uneven heating
• Contributes to safer, more predictable burner performance

• Turn off gas supply and power to the appliance before servicing
• Allow all components to cool completely before handling
• Remove grates and burner caps to access and replace the spreader; reassemble in reverse order

This replacement control knob restores safe, easy control of a Galaxy gas range burner and keeps the cooker looking finished. Satin chrome finish matches original styling and provides a solid grip for burner adjustments. What it does:

• Replaces a cracked, broken, stripped or missing gas control knob so you can turn burners on and off
• Provides a clear pointer for heat setting selection and consistent engagement with the valve stem
• Restores factory appearance by matching the original satin chrome finish
• Helps prevent accidental slippage when adjusting flame settings

• One replacement control knob

• Turn off all burners and ensure controls are cool before removing the old knob
• Most knobs pull straight off the valve stem and push onto the new stem until fully seated
• Verify the replacement knob matches your valve stem style and seating orientation before use
• If a valve or mounting post is damaged, replace that component rather than forcing the knob

This is a stainless-steel M3 x 7 mm countersunk Phillips screw packaged as a set of 10 — a common fastener for securing trim, brackets, and small components in appliances. It provides a flush finish when installed. What it does:

• Secures panels, brackets, and small component assemblies using a countersunk head for a flush fit
• Phillips drive allows standard screwdriver or bit installation
• Stainless finish resists corrosion in typical household appliance environments
• Used where an M3 x 7 mm machine screw is specified

• One packet containing 10 screws (M3 x 7 mm, countersunk Phillips, stainless)

• Use the correctly sized Phillips bit to avoid cam-out and striping
• Tighten until snug; avoid over-torquing which can strip threads or damage components
• If replacing a screw, confirm thread size and head style match the original
• Follow all appliance safety guidance: disconnect power and water before servicing