Parts for Thermador CMT227: Lower Door Parts

This stainless-steel air shield protects airflow channels and internal components from heat and debris, helping maintain proper ventilation and part longevity. Designed as a direct replacement for the listed Bosch shield assembly. What it does

• Directs and protects airflow to help maintain correct internal temperatures
• Shields nearby components from heat and debris that can cause wear or damage
• Restores proper fit and alignment where a damaged or missing shield causes rattle or airflow disruption
• Helps reduce noise caused by loose or missing shielding

• One stainless-steel air shield

• Replace with appliance powered off and disconnected from its power source
• Handle edges carefully; wear gloves to avoid cuts from sharp metal
• Verify orientation and fastener locations before tightening to avoid interference with moving parts
• If screws or clips are missing or damaged, replace them with OEM-specified fasteners

This inner door glass panel replaces the interior glass pane in the door assembly. It restores a clear, heat-resistant barrier so your appliance can retain heat and operate safely after the original pane cracks or shatters.

• Serves as the interior glass pane of the door facing the cavity
• Helps insulate the cavity to maintain stable cooking temperatures
• Direct replacement for cracked, shattered, or missing inner glass
• Can help address heat loss and unsafe door conditions

• Disconnect power at the breaker and allow the appliance to cool completely before starting
• Remove the door per your model's service instructions and place it on a padded work surface
• Wear cut-resistant gloves and eye protection; handle glass by the edges
• Transfer any brackets/clips in the original order and tighten fasteners snugly without overtightening

This replacement shim provides precise spacing and alignment for appliance components, helping secure mounts and maintain proper clearances for reliable operation. Use when parts sit unevenly, rub, or require minor alignment adjustments. What it does:

• Creates or restores correct spacing between mating parts to prevent rubbing and binding
• Helps stabilize and align panels, brackets, or assemblies for smoother operation
• Can reduce vibration and noise caused by misaligned components
• Supports fasteners or mounting points where a thin precision spacer is required

• One shim

• Disconnect power and water (if applicable) before beginning any repair
• Verify correct shim location and orientation against the service manual or parts diagram
• Handle carefully — edges may be sharp; wear gloves if needed