Parts for OR30SLDGX1-70874-A: Main Top Parts

This is a pack of #10 x 3/8 inch Phillips truss-head screws with nickel plating for appliance fastenings. Use them to replace missing or corroded trim and panel screws and restore secure mounting and fit. What it does:

• Fastens trim, panels, brackets and light-duty components where #10 x 3/8 in screws are specified
• Truss head provides a larger bearing surface to reduce pull-through on thin materials
• Phillips drive offers easy, common-driver installation
• Nickel plating resists corrosion for longer-lasting fit in humid areas
• Replacing worn or missing screws can stop rattling, loose panels, and misaligned parts

• Ten #10 x 3/8 in Phillips truss-head nickel-plated screws

• Use the correct-sized Phillips driver to avoid cam-out and damaged heads
• Tighten until snug—do not overtighten to prevent stripping or distorting thin panels
• Disconnect power and remove any panels per appliance instructions before servicing
• Wear safety glasses and keep small parts away from children and pets

Phillips head screw kit for securing panels and components in electric wall ovens, gas ranges, and ranges. Replace missing, stripped, or damaged screws.

Burners won't light or igniter clicks constantly? This spark module generates the electrical spark needed to ignite gas burners. Moderate DIY repair.

Range won't ignite or control panel is unresponsive? This 30mA low-voltage transformer powers ignition and control circuits. Direct fit replacement.