Parts for Thermador PRD366GHU/04: Manifold Assy Parts

This gas pressure regulator controls and stabilizes incoming supply pressure to the appliance manifold, helping ensure consistent burner flames and reliable ignition. Replace if the original regulator is sticking or no longer maintaining correct pressure.

• Regulates incoming gas to the appliance's rated manifold pressure
• Helps maintain even flame height and proper combustion
• Supports reliable burner ignition and reduces flame-out from pressure swings
• Common symptoms include weak or uneven flames, yellow tipping, burners not lighting or not staying lit, or flames that are too high

• Disconnect electrical power and shut off the gas supply before servicing
• Observe the flow-direction arrow; install with outlet toward the appliance manifold
• Use approved gas-rated thread sealant on male threads only and leak-test all joints with a non-corrosive solution after installation

Replacement tube that routes water between appliance components to restore proper flow and prevent leaks. Use this direct-fit tube to replace cracked, brittle, or clogged tubing and stop pooling or improper drainage. What it does:

• Routes water between system components to maintain correct flow
• Prevents leaks and water damage when intact and properly connected
• Helps eliminate pooling, poor draining, or intermittent water delivery caused by damaged tubing
• Fits in-line as the OEM-specified channel for fluid transfer in the appliance

• Disconnect power and shut off the water supply before starting any repair
• Inspect adjoining fittings and seals; replace any damaged clamps or gaskets for a leak-free connection
• Slide the tube fully onto fittings and secure with the correct clamps or fasteners
• After installation, restore power and water, then run a short cycle to check for leaks

Replacement water inlet valve that controls an appliance's incoming water flow for reliable fill and cycle operation. Replacing a faulty valve can stop no-fill, slow-fill, or continuous-fill issues and restore normal performance. What it does:

• Opens and closes to regulate water entering the appliance during fill cycles.
• Helps ensure correct water levels for proper washing or rinsing.
• Common symptom fixer for appliances that won't fill, fill slowly, or keep filling.
• May cause visible leaks at the valve or trigger fill-related fault behavior if failed.

• Turn off power and shut off the water supply before starting any work.
• Open a cycle or relieve pressure to drain residual water before removing the old valve.
• Inspect and replace any worn seals or inlet hoses when installing the new valve.
• Follow the appliance service manual for specific removal/installation steps.