Parts for Speed Queen AFNE9BSP113TN01: Mixing Valve & Dispenser Hose Parts

The Affresh Washer Cleaner 3 Pack is an OEM cleaning accessory designed specifically for washing machines. This multipack contains 3 packets of a proven formula that helps eliminate odors from the washer tub, door, gasket, and drain areas. Regular cleaning is important to remove dirt, soap scum, mildew, and other residue that can build up over time and lead to odors. The Affresh tablets contain oxygen-powered enzymes and fresh scent boosters that are released during the cleaning cycle to safely and effectively eliminate musty smells.

This multipack of Green 4.2-ounce tablets ensures you have enough doses for consistent cleaning to keep your washer smelling fresh. As the #1 recommended washer cleaner brand, Affresh is also compatible for use in Maytag, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and select Kenmore washers.

The Water Valve is an OEM part for Speed Queen washing machines. It is a vital component responsible for controlling water flow into the washer tub during fill cycles. The water valve precisely regulates water pressure and volume to efficiently fill the washer tub without leaks or excess water usage.  

Symptoms of a bad water valve include:

• Slow or erratic water fill 
• Inability to fill the washer tub fully
• Water leaks from the valve area
• Fluctuating or unregulated water pressure  

Causes of a bad water valve can include mineral buildup interfering with valve function, worn seals allowing water to bypass the valve or damage to internal components impeding proper operation.

This small sealing washer fits the washer's water pressure assembly to help maintain a proper watertight seal at the pressure/valve connection. Replacing a worn washer reduces leaks and helps the fill/pressure system operate as intended. What it does

• Provides a watertight seal at the water pressure/valve connection to prevent leaks.
• Helps maintain correct pressure feedback to the washer's water control system.
• Wear or damage can allow leaking at the valve or inconsistent fill behavior.
• Simple, low-cost part commonly replaced when troubleshooting valve leaks.

• Turn off household water supply and unplug the washer before replacing.
• Remove the valve/pressure fitting carefully and replace the old washer with the new one, making sure it seats flat and undamaged.
• Inspect mating surfaces for debris or damage; clean before reassembly.
• If leaks or fill issues persist after replacement, inspect related seals, fittings, and the pressure switch/valve assembly.

This replacement water inlet hose connects the home's water supply to the washer, restoring reliable water flow and preventing leaks at the rear hookup. Use when the original hose is cracked, split, or leaking. What it does:

• Carries incoming water from the fill valve to the tub for normal wash cycles
• Stops leaks caused by worn, cracked, or split inlet tubing
• Helps restore proper water fill when low or no-fill symptoms occur
• Matches OEM routing and connection points for a direct fit

• Disconnect power and shut off the water supply before beginning.
• Inspect and replace any worn clamps or fittings; tighten connections by hand then snug with a tool—do not overtighten.
• After installation, restore water and power, run a short fill cycle, and check all connections for leaks.

This replacement inlet hose carries water from your household supply to the washer, restoring proper fill and preventing leaks. Use it when the washer fills slowly, won't fill, or shows water leakage at the connection. What it does:

• Channels hot and/or cold water from the household supply to the washer's inlet valve
• Restores normal fill behavior when an old or damaged hose causes slow or no fill
• Stops leaks caused by cracked, split or deteriorated hose sections or fittings
• Helps prevent water damage from a failed or leaking supply connection

• Turn off household water supply and unplug the washer before replacing the hose
• Hand-tighten fittings, then snug with a wrench—do not overtighten to avoid damaging threads
• Inspect and replace any damaged washers or seals at the connections

The Affresh Washer Cleaner 3 Pack is an OEM cleaning accessory designed specifically for washing machines. This multipack contains 3 packets of a proven formula that helps eliminate odors from the washer tub, door, gasket, and drain areas. Regular cleaning is important to remove dirt, soap scum, mildew, and other residue that can build up over time and lead to odors. The Affresh tablets contain oxygen-powered enzymes and fresh scent boosters that are released during the cleaning cycle to safely and effectively eliminate musty smells.

This multipack of Green 4.2-ounce tablets ensures you have enough doses for consistent cleaning to keep your washer smelling fresh. As the #1 recommended washer cleaner brand, Affresh is also compatible for use in Maytag, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and select Kenmore washers.