Parts for Thermador PRD486ELG01: Outside Parts

Replace a cracked, warped, or missing burner grate on your gas cooktop. This single grate supports cookware over the flame for stable cooking.

A replacement mounting/support bracket used to secure internal components and panels on compatible Bosch appliances. Restores proper alignment and stability so cabinets and panels stay firmly attached. What it does:

• Secures panels or internal components to the appliance frame to prevent shifting
• Helps maintain proper alignment of doors or panels that may sag or sit unevenly
• Reduces rattling or vibration caused by loose mounting points
• Supports safe operation by keeping parts correctly positioned

• Basic hand tools required; use care to avoid scratching finished surfaces
• Disconnect power to the appliance before servicing to prevent shock or injury
• Inspect surrounding fasteners and mounting points; replace any damaged screws or clips

Replaces the lower kickplate on your range to restore a finished look and protect internal components. Install when your original panel is cracked or damaged.

Replacement bracket for gas ranges. This structural component secures internal parts in place. Order a new bracket if yours is bent, broken, or missing.

This replacement cable harness routes power and signal connections between internal appliance components to restore reliable electrical continuity and component operation. Use it when wiring is damaged or connectors fail. What it does

• Transfers power and control signals between the control board and components (motors, valves, sensors).
• Replaces damaged or frayed wiring that can cause intermittent operation.
• Restores lost function when a failed harness prevents components from receiving power.
• Helps eliminate faults caused by loose, corroded, or broken connector leads.

• Disconnect all power before starting; verify the appliance is de-energized.
• Compare connectors and wire routing to the old harness before removing anything.
• Use proper connector seating and secure clips to prevent pinching or chafing.
• After installation, restore power and run a test cycle to confirm proper operation.

Fix range electrical issues with this wire harness and diode assembly. Restores proper burner ignition and oven function. Moderate DIY repair takes 30-45 minutes.

Range won't power on or has intermittent electrical issues? This cable harness connects control components. Moderate difficulty repair requiring multimeter.