Kenmore Washer 110.26002011 (11026002011, 110 26002011) Parts

Replaced the RING TUB - CAUTION - be careful when the top of the washer is removed ( 2 screws at the rear and pushed forward to release) because the bare steel plates under the top portion are VERY sharp, I used thick rubber gloves and ran a thick wad of sandpaper round all the sharp edges before I started to replace the ring. If you don't you stand a very good chance of a severe cut. The Ring Tub is released by 8 latches round the outer edge. The replacement simply pushes on - make sure they... Read more

Replaced the dispenser housing and bezel plastic trim that holds it in place from the inside. Read more

I followed Matt's awesome video from AppliancePartsPros.com to build up my "I can do this" reserves. But here's the story leading up to that point... We purchased our Samsung WF419 on a “Black Friday” special November 2009 expecting to get some good years out of the washer/dryer pair. We don’t run more than 2 or 3 loads a week in the washer, so ours has had relatively little use over the beginning of its anticipated and expected long life-cycle. When the “thumping” started on the spin cycle a... Read more