Kenmore Washer 110.47532604 (11047532604, 110 47532604) Parts

This toe panel is the lower front trim piece that covers and protects the washer's base, restoring the machine's finished appearance and helping keep internal components free from debris. It replaces a cracked, dented, or missing front kick plate. What it does:

• Covers the lower front of the washer and conceals internal components
• Protects against dust, lint and accidental contact with internal parts
• Restores the washer's appearance after impact or corrosion damage
• Helps reduce drafts and prevents small items from entering the cabinet
• Stops rattling or vibration caused by a loose or broken panel

• Disconnect power and water supply before beginning any service
• Typical installation requires removing the lower access screws or clips and snapping or fastening the panel into place
• Use proper hardware and alignment to avoid gaps or binding; keep fasteners snug but do not overtighten
• Beware of sharp edges; wear gloves and follow model-specific service instructions

This clamp secures flexible hoses and small-diameter tubing to fittings, helping prevent leaks and maintain proper fluid flow in appliance systems. It's a simple replacement that restores a tight, reliable connection. What it does

• Holds a hose or tube firmly on a barb or nipple to stop leaks and loss of pressure
• Keeps water, drain, or vent hoses seated during normal appliance operation
• Replaces worn, corroded, or loose clamps that cause dripping or poor connections
• Works where a small, durable clamp is required for routing or securing tubing

• One hose clamp

• Inspect hose and fitting for damage; replace hose if cracked or hardened before installing the clamp
• Tighten clamp until snug—do not overtighten; ensure even compression around the hose
• Disconnect power and water as appropriate and take safety precautions before working on the appliance

This clamp secures a flexible appliance hose to a fitting to help prevent leaks and keep connections tight. It's a small but essential part that restores a proper seal on water or drain lines. What it does:

• Holds a hose firmly to a tailpiece, barb or connector to reduce leaks and hose slippage
• Helps stop intermittent dripping or pooling caused by loose hose connections
• Restores a proper seal after hose replacement or maintenance
• Works on common appliance water/drain lines where this clamp style is used

• One hose clamp

• Disconnect power and shut off water to the appliance before starting any work
• Allow the appliance and hoses to cool if recently used; use gloves and eye protection
• Use appropriate pliers or a screwdriver (depending on clamp style) to remove and install the clamp; avoid over-tightening
• Inspect the hose and fitting for damage; replace the hose if cracked or worn