Kenmore Washer 110.47576603 (11047576603, 110 47576603) Parts

This toe panel is the lower front trim piece that covers and protects the washer's base, restoring the machine's finished appearance and helping keep internal components free from debris. It replaces a cracked, dented, or missing front kick plate. What it does:

• Covers the lower front of the washer and conceals internal components
• Protects against dust, lint and accidental contact with internal parts
• Restores the washer's appearance after impact or corrosion damage
• Helps reduce drafts and prevents small items from entering the cabinet
• Stops rattling or vibration caused by a loose or broken panel

• Disconnect power and water supply before beginning any service
• Typical installation requires removing the lower access screws or clips and snapping or fastening the panel into place
• Use proper hardware and alignment to avoid gaps or binding; keep fasteners snug but do not overtighten
• Beware of sharp edges; wear gloves and follow model-specific service instructions

This central control unit is the electronic control board that manages the appliance's functions and user interface, restoring reliable command of cycles, timing and displayed information when the original control fails. What it does:

• Controls and coordinates appliance cycles, timers and user inputs via the main control circuitry
• Replaces a failed or unresponsive control board causing loss of control or incorrect cycle behavior
• Helps resolve symptoms such as no display response, unresponsive touchpad/controls, or appliances that won't start or complete cycles
• Interacts with sensors and relays to run motors, valves and heaters per programmed cycles

• Disconnect power before servicing to avoid shock or damage to the board
• Handle the control board by its edges and avoid static discharge; use a grounded wrist strap if available
• Verify your appliance model number and part number (WPW10679605) before ordering and installing

This clamp secures flexible hoses and small-diameter tubing to fittings, helping prevent leaks and maintain proper fluid flow in appliance systems. It's a simple replacement that restores a tight, reliable connection. What it does

• Holds a hose or tube firmly on a barb or nipple to stop leaks and loss of pressure
• Keeps water, drain, or vent hoses seated during normal appliance operation
• Replaces worn, corroded, or loose clamps that cause dripping or poor connections
• Works where a small, durable clamp is required for routing or securing tubing

• One hose clamp

• Inspect hose and fitting for damage; replace hose if cracked or hardened before installing the clamp
• Tighten clamp until snug—do not overtighten; ensure even compression around the hose
• Disconnect power and water as appropriate and take safety precautions before working on the appliance