Kenmore Washer 110.5905602 (1105905602, 110 5905602) Parts

Type AB #8-18 x 5/8 inch thread-forming screw secures panels and components in appliances. Replace missing, stripped, or corroded fasteners.

Supports the spin basket on the center post for smooth, quiet rotation. Replace if your washer is noisy, vibrating excessively, or has poor spin performance.

Rubber washer gasket for washer fill hose connections. Replace if worn or leaking at coupler adapter. Measures 1-1/16 x 5/8 inch. Verify fit with model.

10-16 x 5/8 inch mounting screw for washers and dryers. Replaces rusty, corroded, or broken screws that secure console panels and internal components.

Right-hand lid hinge for washer tops. Replaces worn, rusted, or broken hinges that cause lids to sag or not open smoothly. Direct fit replacement.

Small metal spacer washer that distributes load and maintains alignment in washer assemblies. Replace when worn, missing, or damaged to restore secure fit.

Knurled pin secures knobs or dials to control shafts in washers. Replace if the original is missing, worn, or damaged to stop loose or spinning knobs.

Replaces a cracked, leaking, or worn washer fill hose. Connects your water supply to the washer inlet. Essential when your old hose shows damage.

Leaking water connection? This hose coupling creates a secure seal between your washer hose and water inlet, stopping drips and loose connections. DIY fix.

Secures wire harness connections in your washer. Replace if clip is broken, cracked, or missing to prevent loose wiring. Verify fit with your model number.

Rubber cushion bumper that protects moving parts and panels in your dishwasher. Replace if cracked, missing, or worn to restore proper spacing.

Fix a washer that won't change water temperature or cycles incorrectly with this water temperature switch. Simple repair restores proper wash cycle control.

Upper drain hose with elbow fitting for washers. Replaces cracked, leaking, or damaged drain hoses that cause water drainage issues during wash cycles.

Replace your washer's drain hose when cracked, kinked, or leaking. This tube connects the pump to the drain outlet, routing wastewater out of the machine.

Mounting nut for washer assemblies. Secures components and panels in place. Replace if stripped, corroded, or missing to restore proper fastening.

Hinge pad cushions the dryer door hinge connection. Replace if your original pad is cracked, worn, compressed, or missing to restore proper door support.