Kenmore Washer 110.7104900 (1107104900, 110 7104900) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP98997
$7.48
- Compare At:
-
$7.65
- You Save:
-
$0.17
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: 18849
$13.61
- Compare At:
-
$16.33
- You Save:
-
$2.72
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: 90984
$19.95
- Compare At:
-
$23.54
- You Save:
-
$3.59
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: 96894
This 15-way terminal plug provides the wire-to-wire connection used on select appliance control assemblies, restoring secure electrical connections and reliable signal/power routing. Fits into the matching terminal block for proper electrical contact. What it does:
- Re-establishes a 15-position connector between wiring harness and control/terminal block
- Helps stop intermittent operation caused by loose, damaged, or corroded plug connections
- Ensures correct routing of power and control signals when mating terminals are secure
- Used wherever a 15-way plug interface is specified on the appliance wiring harness
What's included:
Install notes:
- Disconnect power to the appliance before servicing to avoid shock or injury
- Handle terminals and wires gently to avoid bending or damaging contacts
- Confirm plug orientation and full seating into the mating terminal block during installation
- If mating terminals or wiring are damaged or corroded, replace those components as well
More
$15.60
- Compare At:
-
$18.72
- You Save:
-
$3.12
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: 18642
Genuine Whirlpool part
By: Whirlpool
Part Number: 350367
4 port. Whirlpool and Kenmore washers.
More
Genuine Whirlpool part
By: Whirlpool
Part Number: 350384
Plunger kit includes: Plunger, rivit and nylon insert.
Do-It-Yourself Stories from Customers like You
Worn and bent wig wag solenoid plunger Rob H. • Denver , CO • November 16, 2015
Replaced it:
Loosened and lifted the wig wag solenoid
used a drill with grindstone and ground off the rivet head, swapped the new part in... BUT... the kit didnt contain the rivet clip so I had to hit the hardware store for a pushnut that fit, hopefully it will stay on.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: 350532
Genuine Whirlpool part
By: Whirlpool
Part Number: 354244
Genuine Whirlpool part
By: Whirlpool
Part Number: 359689
Genuine Whirlpool part
By: Whirlpool
Part Number: 487596
Genuine Whirlpool part
By: Whirlpool
Part Number: 76673
Includes 4 rubber washers, 4 metal washers, and 4 screws.
More
Genuine Whirlpool part
By: Whirlpool
Part Number: 84867
Do-It-Yourself Stories from Customers like You
Kenmore Series 70 Washer Not Spinning Kenneth W. • Monterey Park , CA • March 16, 2014
Our Kenmore Series 70 washer no longer spun during the rinse and spin cycle. After scouring the resource on the internet, the lid switch checked out OK, so it boiled down to the wig wag solenoid unit that engages the transmission. The back panel was opened and a check with a multimeter showed one of the solenoids was an open circuit and provided no resistance reading.
Removal of the old unit required some finessing with a prying tool and hammer to force it off of the shaft. The new unit...
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: 96384
Genuine Whirlpool part
By: Whirlpool
Part Number: 96388
Genuine Whirlpool part
By: Whirlpool
Part Number: 98669
Do-It-Yourself Stories from Customers like You
The door switch failed when the door was opened the machine still ran Peter B. • Davie , FL • July 10, 2016
Replaced the switch...your videos are great! Five minutes and the job was done..OK,maybe ten,but with no swearing either!
Read more
More