Kenmore Dryer 110.77032601 (11077032601, 110 77032601) Parts

This replacement mounting screw secures appliance panels and small components to restore proper fit and reduce movement. It's a simple, direct part for repairing loose panels, trim, or interior assemblies. What it does:

• Fastens panels, brackets, or assemblies to prevent rattling and vibration
• Restores proper alignment for doors, control panels, or trim pieces
• Helps stop intermittent noise caused by loose hardware
• Use when original screw is missing, stripped, or corroded

• Disconnect power and unplug the appliance before beginning any repair
• Use the correct screwdriver bit and hand-tighten; avoid over-torquing which can strip threads
• Keep small parts away from children and pets; magnetic tray helps prevent loss
• If multiple screws are corroded or hardware threads are damaged, inspect mating parts and replace as needed

This genuine wire harness is the complete wiring assembly that routes power and control signals between the appliance's control and its components, restoring reliable electrical connections and consistent operation. What it does:

• Routes power and control signals between the control board and components
• Replaces damaged or frayed wiring that can cause intermittent operation
• Restores continuity to components that fail to receive power
• Helps eliminate visible burn marks, melted insulation, or loose connector issues

• Disconnect power before starting any repair to avoid electrical shock
• Label or photograph existing wire locations before removing the old harness to ensure correct reconnection
• Inspect connectors and mating terminals for damage; replace any damaged hardware separately
• Secure harness away from moving parts and heat sources; test appliance function after installation

This cable tie secures wiring and the power cord to the appliance chassis to help prevent chafing, pinching, or loose connections. Simple, low-cost part that restores proper wire routing and strain relief. What it does

• Holds wiring and harnesses in place to prevent rubbing against sharp edges
• Helps reduce risk of intermittent power or connector strain caused by loose wires
• Keeps harnesses routed for correct clearance and component access
• Useful during repairs to restore original wire routing and strain relief

• One cable tie (wire harness retainer)

• Safety first: disconnect the appliance from power before inspecting or replacing wiring components
• Remove the damaged or existing retainer and route harnesses to match original OEM routing before installing the new tie
• Trim excess tie tail; do not overtighten—secure, but avoid crushing wires
• Replace any tie that's melted, cracked, or otherwise damaged rather than reusing it