Kenmore Washer 110.82060100 (11082060100, 110 82060100) Parts

Our Kenmore Series 70 washer no longer spun during the rinse and spin cycle. After scouring the resource on the internet, the lid switch checked out OK, so it boiled down to the wig wag solenoid unit that engages the transmission. The back panel was opened and a check with a multimeter showed one of the solenoids was an open circuit and provided no resistance reading. Removal of the old unit required some finessing with a prying tool and hammer to force it off of the shaft. The new unit... Read more

Replaced the switch...your videos are great! Five minutes and the job was done..OK,maybe ten,but with no swearing either! Read more

Water outlet was full of metal chips.Cleaned out chips and installed new pump. Read more

Researched this kenmore washer on-line and found the problem to be the lid switch. Saw a diagram on how to jump this switch by connecting a wire to both outside wires on the harness and voila! It worked! This is not a fix but it allowed me to finish the load of unwashed clothes and told me which part was bad (do not run washer jumped like this.......fire hazard!) Ordered the lid switch and it was an easy repair. A $14.00 switch was a lot cheaper than a $450.00 washer. Thanks appliance parts... Read more