Kenmore Washer Dryer Combo 110.88732790 (11088732790, 110 88732790) Parts

This outer refrigerator door replaces a damaged or worn exterior door panel so your fridge seals and looks like new. It restores proper closure and helps maintain internal temperature control and appliance appearance. What it does:

• Replaces a damaged, dented or cracked outer refrigerator door panel
• Restores a straight, secure door edge for better sealing and operation
• Helps prevent cold air loss that can cause temperature fluctuations
• Improves appliance appearance by replacing scratched or faded exterior finish

• One outer refrigerator door panel

• Disconnect power and empty the door before starting; remove any screws or hinge covers securing the door
• Lift or support the door while removing hinge fasteners to avoid dropping or damaging the cabinet
• Align hinges and test door swing and seal before tightening all fasteners
• If inner components (bins, trim, gaskets) are attached, they should be properly reinstalled or transferred per manufacturer instructions.

Kit includes 2 sleeves.

This replacement button bar restores the row of pushbuttons on the control panel so you can operate your appliance's functions easily. It replaces cracked, worn, or missing button strips and helps return normal button feel. What it does:

• Provides the pushbutton interface that actuates the control switches behind the panel
• Aligns and secures into the control console so each button depresses cleanly
• Common symptoms it fixes: broken, loose, missing, or sticky buttons and intermittent button response
• Matches factory fit and mounting points for a straightforward panel replacement

• Disconnect power (unplug or shut off breaker) before starting any repair
• Typically installed from the front or back of the control console after removing the console or trim
• Handle plastic tabs gently to avoid breaking mounting clips during removal/installation

This console clip secures the appliance control console or control panel to the cabinet, restoring a snug, stable fit and stopping rattles or loose movement. Durable plastic clip designed to replace a broken or worn fastener. What it does:

• Holds the control console in place to prevent sagging or separation from the cabinet
• Stops rattling or vibration noise caused by a loose console
• Restores proper alignment for buttons and switches on the control panel
• Replaces a cracked, worn, or missing mounting clip

• One console mounting clip (1 each)

• Disconnect power before attempting any service to avoid shock or injury
• Remove the console or access panel per your model's service instructions to reach the clip
• Pry out the damaged clip carefully and snap the new clip into the factory mounting boss until it seats
• Handle plastic parts gently to avoid cracking; before reassembling