Kenmore Washer Dryer Combo 110.98673830 (11098673830, 110 98673830) Parts

This drain tube funnels and directs excess water away from the appliance to the drain path, helping prevent pooling and water damage. It replaces a worn, cracked or clogged tube to restore proper water flow. What it does:

• Carries water from the appliance's drainage area to the drain outlet
• Helps prevent leaks and interior water buildup from a damaged or disconnected tube
• Can resolve symptoms like water pooling under/behind the appliance or intermittent draining
• Ensures proper routing so water flows to the drain instead of into the cabinet

• One drain tube

• Disconnect power to the appliance before starting any repair
• Turn off water supply and remove any panels needed to access the tube
• Inspect and replace any worn clamps or fasteners; ensure tube is routed without kinks
• After installation, restore power/water and run a test cycle to ensure there are no leaks

Use with motor 357282.

This terminal block access cover protects the appliance's electrical connection area, helping keep wires shielded and reducing the risk of accidental contact. It restores the factory appearance and helps maintain safe operation. What it does:

• Shields the terminal block and wiring from dust, debris, and accidental contact
• Helps prevent shorting or arcing at the power connection area
• Restores a finished look after service or replacement of wiring components
• Supports safe access control by covering live terminals when installed

• Disconnect power at the breaker or unplug the appliance before servicing.
• Remove or loosen the mounting fasteners for the old cover, then position and secure the replacement cover.
• Verify the cover fits flush and does not pinch wiring; ensure all connections are tight before restoring power.

Motor mount to gear case.

This block restraint is a small mounting block that secures internal components and limits movement to reduce noise and wear. It restores proper alignment and keeps parts from shifting during operation. What it does:

• Anchors and stabilizes nearby components to prevent excessive movement and vibration
• Helps reduce rattling or banging noises caused by loose internal parts
• Keeps parts aligned to prevent premature wear or abrasion
• Supports safe, reliable operation by holding components in the intended position

• One block restraint

• Disconnect power (and water for washers/dishwashers) before beginning any repair
• Access the mounting location by removing the appropriate panel(s); basic hand tools typically required
• Remove the old block and replace with the new restraint; ensure correct orientation and secure fit
• Inspect surrounding fasteners and mounting surfaces; do not overtighten plastic parts

Color: White. Size: 1 qt. can. Acrylic appliance paint.

This ignition electrode delivers the spark needed to light the burner in compatible gas ovens and ranges, restoring reliable ignition so burners and bake/broil functions light properly. What it does:

• Produces the spark for the gas burner to ignite
• Helps ensure consistent ignition timing and burner starts
• Commonly used when a burner fails to light or ignition is intermittent
• Works with the oven/range ignition system to start bake and broil cycles

• Disconnect power and shut off the gas supply before starting any repair
• Handle the ceramic/insulated tip carefully to avoid cracking or contamination
• Verify correct electrode position and secure mounting for reliable sparking

This cove transition panel is the black trim piece that restores the look and fit between your cooktop and control area. It provides a finished appearance and replaces a cracked, bent, or missing transition trim. What it does:

• Covers the gap between the cooktop and control/cabinet area for a clean, finished appearance
• Replaces damaged, cracked, or warped trim that can affect panel alignment
• Helps maintain correct spacing and fit of adjacent trim pieces
• Restores original factory appearance after collision or wear

• Disconnect power to the appliance before starting any work
• Handle edges carefully to avoid cuts and prevent scratching the finish
• Minor disassembly of surrounding trim or panels may be required; keep fasteners organized