Kenmore Freezer 253.11541100 (25311541100, 253 11541100) Parts

This main wiring harness connects the appliance's control components and power distribution, restoring electrical pathways so controls, sensors, and motors can operate correctly. Replace a damaged harness to regain reliable electrical continuity and signal routing. What it does

• Routes power and control signals between the appliance control board, switches, sensors, and motors.
• Restores electrical continuity when broken, cracked, or melted wires cause intermittent or no operation.
• Helps eliminate faults caused by shorted or corroded connector pins and damaged insulation.
• Supports normal operation of the user interface and protected components by keeping wiring organized and secured.

• One main wiring harness assembly as pictured.

• Disconnect power (unplug or switch off breaker) before starting any repair to avoid shock or equipment damage.
• Verify the harness matches the connector types and mounting points on your appliance before installation.
• Use proper strain relief and routing to avoid pinched wires; replace any damaged clips or grommets.

A small replacement mounting clip that secures interior trim and panels to restore proper fit and reduce rattling. Use when a broken or missing clip leaves gaps or lets panels or trim sit loose on the appliance. What it does:

• Secures trim, access panels or small plastic covers to the appliance frame
• Restores proper alignment and helps eliminate panel vibration or rattling
• Replaces cracked, worn or missing clips that allow gaps or loose parts
• Works as a simple fastener where the original clip has failed

• Always disconnect power to the appliance before beginning any repair
• Clip typically installs with a push-fit or snap-in motion; a flat tool may help remove the old clip
• Handle surrounding trim gently to avoid cracking brittle plastic
• Verify correct clip orientation before snapping into place

This replacement washer lid restores the top cover that keeps the wash tub closed during operation, helping contain water and suds and allowing the lid safety switch to function properly. Fits the original top-load washer configuration. What it does

• Covers the washer tub to prevent water and detergent from escaping during cycles
• Works with the lid safety/interlock so the machine can operate when closed
• Replaces cracked, warped, or missing lids that won't seal or latch correctly
• Helps reduce noise and keeps the wash area protected from debris

• Disconnect power and water supply before starting any repair
• Remove and reinstall using the original hinge screws or mounting hardware
• Align lid with hinge pins and test that it opens, closes, and latches smoothly
• Verify switch engagement and operation after installation