Kenmore Freezer 253.13541102 (25313541102, 253 13541102) Parts

This genuine appliance screw secures panels and components to keep your refrigerator parts aligned and stable. A small but essential fastener, it restores proper fit and stops rattling or loose trim for reliable operation. What it does:

• Fastens panels, trim, or internal components to the appliance frame
• Restores secure fit when factory screws are missing or stripped
• Stops vibration- or temperature-related rattling caused by loose hardware
• Helps maintain proper spacing and alignment of serviceable parts

• Turn off and unplug the appliance before servicing electrical or internal areas
• Use the matching screw hole and thread engagement; start by hand to avoid cross-threading
• Tighten until snug—do not overtighten to prevent stripping or cracking surrounding material

This electronic controller board manages key refrigeration functions and defrost routines so your appliance maintains proper temperatures. Replacing a failed board can restore automatic operation when cooling becomes erratic or frost buildup starts affecting performance.

• Governs programmed cooling and defrost cycles to help prevent frost accumulation and temperature swings
• Sends power to components per the control program, enabling fans, compressor, and heaters to run at the right time
• Typical failure signs: heavy frost on the evaporator, warm or no-cool conditions, nonstop running or short cycling, unresponsive controls
• May show visible damage such as burnt spots or a burnt odor on the board

• Disconnect power before servicing; use ESD protection and handle the board by the edges
• Access location varies by model; photograph wiring and move connectors one at a time to the new board
• Mount securely and ensure all harnesses are fully seated; avoid pinching wires during reassembly
• If frost was present, fully defrost the evaporator after installation and allow temperatures to stabilize after restoring power

The lower basket holds and organizes items in the bottom section of the freezer. Replace a bent, broken, or missing basket to restore tidy storage and easier access to food in the lower compartment.

• Provides stable, contained storage in the lower freezer area
• Replaces a damaged, bent, rusted, or missing lower basket
• Helps keep food visible and accessible, reducing clutter
• If the basket won't sit level or shows broken wires/coating, replacement is recommended

• Unplug the appliance before servicing
• Empty the compartment and lift out the old basket
• Set the new basket onto the lower supports and ensure it sits level and secure
• Reload items evenly to prevent tipping

This top washer lid replaces a cracked, chipped or faded cover to restore the washer's top closure and appearance. A direct-fit cosmetic panel that helps keep clothes and water inside the tub while the machine is in use. What it does:

• Replaces a damaged or worn top lid to restore full closure and a clean appearance
• Helps prevent splashes and keeps items from falling into the washer during operation
• Restores correct alignment for the lid so the washer door closes securely
• Useful when lid is cracked, warped, or cosmetically damaged

• One white top lid

• Disconnect power and water supply before starting any repair to avoid shock or injury
• Support the lid while removing or fastening mounting hardware to prevent dropping or damage
• Reuse existing hinges and screws unless replacements are specified for your model
• If you see additional damage to hinges or latch components, inspect and replace those parts separately