Kenmore Freezer 253.23024103 (25323024103, 253 23024103) Parts

This cable clip secures a refrigerator's wire harness or control cables, keeping wiring routed and protected to prevent pinching or contact with moving parts. A small but important retainer for safe, tidy internal wiring. What it does:

• Holds and routes wire harnesses or cables to prevent interference with drawers, doors, or moving components
• Reduces wear and chafing on wires by keeping them away from sharp edges and heat sources
• Helps maintain reliable electrical connections by preventing strain on harnesses
• Commonly replaced when clips are broken, cracked, or missing and wires become loose or misrouted

• Turn off power to the appliance before accessing internal wiring
• Install by snapping clip onto designated frame or mounting boss and seating wire(s) into the clip
• Replace any damaged wiring or connectors discovered during installation

This outer door panel replaces a damaged or dented refrigerator door surface to restore appearance and protect internal door components. It provides a clean, finished exterior and is a direct-fit body panel designed to match the original door construction. What it does:

• Covers and protects the door frame, insulation, and internal components from damage and moisture
• Restores a smooth, uniform exterior after dents, deep scratches, or paint damage
• Helps maintain a proper seal by providing the correct mounting surface for gaskets and trim
• Prevents further cosmetic deterioration and preserves appliance resale value

• One outer door panel

• Handle with care to avoid bending or scratching the panel during installation
• Disconnect power and empty door pockets/drawers before removing the door or inner liners
• Use appropriate fasteners and torque per manufacturer guidelines to ensure proper alignment

This control panel overlay is the thin front decal that covers the appliance console and provides the labeled touchpoints for buttons and indicators. It restores legibility and the original appearance of the control area. What it does

• Replaces a worn, faded, or scratched control panel decal so button labels and icons are readable again
• Protects the underlying control assembly from everyday wear and light spills
• Helps restore the appliance's cosmetic appearance and makes controls easier to use
• Useful when the original overlay is peeling, discolored, or has missing graphics

• One control panel overlay

• Disconnect power to the appliance before beginning any work to avoid shock or injury
• Remove the control or console trim per the appliance service instructions to access the old overlay
• Peel the old decal carefully; clean the surface of residue and oils before applying the new overlay for proper adhesion
• Align the new overlay precisely and press firmly; do not reuse adhesive if the part is a replacement decal with pre-applied adhesive

This replacement nameplate restores the front identification badge and cosmetic finish on the appliance, helping the unit look complete and factory-original again. It's a direct-fit exterior badge used where the original label has worn or fallen off. What it does:

• Replaces a missing, peeled, or faded exterior nameplate to restore the appliance's appearance.
• Serves as the decorative identification badge that mounts to the appliance surface.
• Helps prevent sharp edges or loose fragments from remaining after the old badge is removed.
• Useful when the original nameplate is cracked, scratched, or no longer adheres.

• One replacement nameplate

• High-level, safety-first: always unplug the appliance or disable power at the breaker before starting work near electrical components.
• Remove the old nameplate and any leftover adhesive or debris; clean and dry the mounting surface before installing the new badge.
• Align the new nameplate carefully and press firmly; handle with gloves to avoid fingerprints or cuts from edges.
• If fasteners or adhesive are required, use the OEM-specified method.