Kenmore Freezer 253.29111991 (25329111991, 253 29111991) Parts

This Hose-Drain is the appliance drain line that carries waste water away from the unit to the household drain, helping restore proper draining and prevent water buildup. Replace a cracked or clogged hose to stop leaking and poor drain performance. What it does:

• Channels wastewater from the appliance to the household drain or disposal
• Restores normal draining when a worn or damaged hose causes pooling or slow drain
• Helps prevent leaks and water damage caused by cracks, splits, or loose connections
• Works with the appliance's existing clamps and fittings to maintain a sealed drain path

• One Hose-Drain

• Disconnect power and water supply before servicing; follow appliance safety guidelines
• Inspect and reuse or replace clamps/fittings as needed for a secure seal
• Route the hose to match the original path, avoiding kinks or tight bends
• After installation, run a short cycle and check all connections for leaks

This retainer lead wire secures appliance wiring to keep harnesses organized and away from heat or moving parts, reducing wear and accidental disconnection. It's a simple replacement to restore proper wire routing and protection. What it does:

• Clips or holds the wiring harness in place to prevent chafing and strain
• Helps keep wires away from hot surfaces, vents, or moving components
• Reduces risk of intermittent electrical connections caused by loose wiring
• Restores factory routing after service or component replacement

• Disconnect power to the appliance before installing to avoid shock or injury
• Remove any panels necessary to access the original retainer and wiring route
• Replace like-for-like, seating the retainer securely so the harness cannot shift
• If wires show damage or insulation wear, inspect further and replace damaged wiring before reassembly

This outer door panel replaces a damaged or worn exterior panel to restore the refrigerator door's appearance and structural coverage. It gives the door a finished exterior surface and supports attached trim and handle areas. What it does:

• Covers the exterior side of the refrigerator door and provides the finished outer surface.
• Restores damaged, dented, or scratched door exteriors for improved appearance.
• Supports attachment points for door trim, handle areas and exterior components.
• Helps protect internal door components from everyday bumps and wear.

• Disconnect power and empty the door before starting work; remove food and loose shelves.
• Typical installation requires removing the door handle and inner door liner to access mounting points.
• Handle panels, trim clips or screws are often removed/reinstalled during replacement; confirm whether existing fasteners are reusable.