Kenmore Refrigerator 253.31438100 (25331438100, 253 31438100) Parts

Secures motor wiring in your refrigerator. Replace if adhesive fails or clamp breaks, causing loose wires. Confirm fit with your model number.

Center hinge bracket for refrigerators in bisque finish. Mounts between doors to support door alignment. Replace if cracked, broken, or worn.

This coil cover seal is a replacement gasket that fits around the evaporator/coil cover to help maintain an airtight seal and reduce frost and moisture buildup. It restores proper airflow control for more consistent cooling. What it does:

• Seals the coil/evaporator cover to limit warm, moist air entering the coil area
• Helps reduce frost or ice accumulation on the evaporator coil
• Supports efficient cooling and stable compartment temperatures
• Can stop short-cycling or extended run times caused by air leaks
• Prevents moisture intrusion that can lead to corrosion or odor issues

• Disconnect power to the appliance before beginning any repairs
• Remove any shelving or covers needed to access the evaporator/coil cover per your service instructions
• Clean mating surfaces and seat the seal fully around the coil cover for an even contact
• If adhesive is used, use OEM-recommended tape or adhesive and allow proper cure time before re-energizing

This outer freezer door panel restores the exterior appearance and protective surface of the freezer door. It replaces a dented, scratched, or corroded panel so the freezer looks finished and resists everyday wear. What it does:

• Replaces the damaged outer surface of the freezer door to improve appearance.
• Protects internal door components and insulation from impacts and moisture.
• Helps seal and align the door edge when installed correctly.
• Commonly replaced for visible dents, scratches, peeling, or rust on the door exterior.

• Intended for replacement by someone comfortable with appliance trim removal; retain all screws and clips during disassembly.
• Disconnect power (and empty the door area) before starting to avoid injury and damage.
• Handle edges carefully to avoid cuts and protect finished surfaces from scratches.
• Fit and final alignment may require minor adjustment of door trim or hinges; follow OEM diagram for correct fastener locations.

Replaces missing, cracked, or broken plug button inserts on your dryer control panel. Restores proper appearance and button operation.

Secures and protects wiring harness from strain damage. Replace if cracked, broken, or wires show wear. Verify fit with your model number listed.