Kenmore Refrigerator 253.31644100 (25331644100, 253 31644100) Parts

Replacement foam insulation for refrigerator evaporator block. Installs around evaporator assembly to maintain temperature efficiency. Replace if worn or missing.

Secures and organizes wiring harnesses in your refrigerator. Replace if broken, cracked, or wires are loose. Confirm fit with your model number.

Refrigerator not cooling properly? This compressor tube connector links sealed system components. Professional installation required for refrigerant work.

Replacement screw for various appliances. Used to secure panels, components, or housing. Replace if stripped, corroded, missing, or damaged hardware.

Secures electrical components to your freezer compressor. Replace if damaged, loose, or during compressor service. Verify fit with your model number.

White plastic plug insert that covers foam holes in refrigerator cabinet panels. Replaces missing, cracked, or damaged hole plugs for a clean finish.

Replaces a broken or worn refrigerator door stop that limits door travel. Prevents over-rotation damage to hinges and cabinet. Restores smooth closing.

Replacement access cover panel for refrigerators. Closes service openings and protects internal components. Needed when original is cracked or missing.

Replacement mounting screw for securing the defrost timer assembly to the refrigerator control housing. Prevents timer from shifting or vibrating.

This replacement nameplate insert restores the control-panel trim and appearance on compatible Frigidaire appliances. It provides a clean, finished surface around buttons and displays to improve usability and appliance aesthetics. What it does:

• Replaces a cracked, faded, or missing control-panel nameplate for a like-new look
• Restores labeled areas and trim around buttons and touch controls for clearer operation
• Helps protect underlying control components from dirt and wear
• Addresses cosmetic damage and improves resale or staging appearance

• One nameplate insert as shown

• Intended as a direct-fit cosmetic replacement;
• Remove power to the appliance before accessing the control panel to avoid shock or accidentally activating controls
• Handle trim carefully to avoid scratching the finish; use appropriate trim tools to release clips or fasteners
• If adhesive or clips are damaged, replace only with OEM-specified fasteners or adhesive

Secures motor wiring in your refrigerator. Replace if adhesive fails or clamp breaks, causing loose wires. Confirm fit with your model number.

Center hinge bracket for refrigerators in bisque finish. Mounts between doors to support door alignment. Replace if cracked, broken, or worn.

This coil cover seal is a replacement gasket that fits around the evaporator/coil cover to help maintain an airtight seal and reduce frost and moisture buildup. It restores proper airflow control for more consistent cooling. What it does:

• Seals the coil/evaporator cover to limit warm, moist air entering the coil area
• Helps reduce frost or ice accumulation on the evaporator coil
• Supports efficient cooling and stable compartment temperatures
• Can stop short-cycling or extended run times caused by air leaks
• Prevents moisture intrusion that can lead to corrosion or odor issues

• Disconnect power to the appliance before beginning any repairs
• Remove any shelving or covers needed to access the evaporator/coil cover per your service instructions
• Clean mating surfaces and seat the seal fully around the coil cover for an even contact
• If adhesive is used, use OEM-recommended tape or adhesive and allow proper cure time before re-energizing