Kenmore Refrigerator 253.57672791 (25357672791, 253 57672791) Parts

This air duct cover channels cold air from the evaporator into the refrigerator/freezer compartment to help maintain even temperatures and proper airflow. It replaces damaged or missing duct covers to restore normal air circulation. What it does:

• Directs cooled air from the evaporator into compartments to reduce hot spots and improve cooling consistency
• Helps prevent direct frost buildup on stored items by guiding airflow
• Restores proper airflow when a cracked or broken cover allows air leaks
• Supports proper defrost cycle airflow when installed correctly

• One air duct cover

• Disconnect power before servicing to avoid electrical shock
• Remove shelves and access panels as needed to reach the duct; handle plastic parts gently to avoid cracking
• Snap into place or secure with the factory screws/fasteners—do not force parts that do not align

This tube clamp secures small tubing and lines inside the appliance to prevent movement and reduce wear. It keeps hoses and tubes routed properly so they don't rub against sharp edges or vibrate during operation. What it does:

• Holds water, drain or refrigerant tubing in place to prevent sagging and chafing
• Reduces vibration and rattling from loose lines
• Helps prevent tubing wear that can lead to leaks or pinch damage
• Keeps hoses routed neatly for reliable appliance operation

• Disconnect power and shut off water supply before beginning any repair
• Remove any access panels needed to reach the clamp location; use caution around sharp sheet metal
• Replace only the damaged clamp with the same style and secure tubing firmly but without over-tightening
• If tubing shows damage where it was rubbing, replace or repair the tubing before reinstalling the clamp

This wiring harness connects the freezer control wiring and related components to restore reliable electrical connections in the freezer compartment. It routes and terminates control and power circuits so the freezer's control board and components can communicate and receive power. What it does:

• Transfers power and signals between the freezer control assembly and components
• Replaces damaged or burned connectors and wires that cause intermittent or no power to freezer controls
• Helps resolve symptoms such as controls or display not responding, intermittent operation, or a freezer section that won't run due to wiring faults
• Restores secure plug-and-play connections when original harness terminals are corroded or broken

• One wiring harness for freezer controls

• Disconnect power to the appliance before inspecting or replacing the harness to avoid shock or damage
• Match connectors carefully; do not force connectors together—align pins and clips before seating
• Route the harness away from sharp edges, moving parts, or heat sources and secure with existing clips or tie straps
• If other wiring or components look damaged, inspect those areas; replace only verified faulty parts

This compressor mounting pin secures the refrigerator compressor to its mounting bracket, helping reduce vibration and noise for reliable operation. It's a simple, rugged fastener used where the compressor meets the cabinet base. What it does:

• Anchors the compressor to the mounting bracket to limit movement and vibration
• Helps reduce compressor-related rattling or banging noises during operation
• Maintains proper compressor alignment to protect refrigerant lines and electrical connections
• Works with existing mounts and brackets as shown in OEM diagrams

• One compressor mounting pin

• Disconnect power and unplug the appliance before accessing the compressor area
• Support the compressor and attached lines before removing or installing mounting hardware
• Use appropriate hand tools and follow OEM diagram locations for correct placement

Specs: Hex head , 8 - 15a x 1.000