Kenmore Refrigerator 253.57687791 (25357687791, 253 57687791) Parts

Channels cold air from the evaporator into the refrigerator and freezer compartments. Replace if cracked, broken, or missing to restore proper airflow.

Replacement mounting screw for refrigerator assembly. Secures components and panels in place. Order if original screw is stripped, missing, or damaged.

Plastic air duct cover deflector that directs airflow in your refrigerator. Replace if cracked, broken, or missing to restore proper air distribution.

Secures water, drain, and refrigerant tubing to prevent movement and wear. Replace if tubes are loose, vibrating, or damaged. Verify fit with model number.

Almond cabinet corner trim piece for freezers. Replaces cracked, broken, or missing corner trim. Installs on exterior cabinet edges for a finished look.

Replace a worn, broken, or missing door spring in your refrigerator. This spring provides tension for smooth door operation and proper closure.

Replace your refrigerator compressor washer if you hear excessive vibration or rattling noise. This rubber washer dampens compressor movement and noise.

This wiring harness connects the freezer control wiring and related components to restore reliable electrical connections in the freezer compartment. It routes and terminates control and power circuits so the freezer's control board and components can communicate and receive power. What it does:

• Transfers power and signals between the freezer control assembly and components
• Replaces damaged or burned connectors and wires that cause intermittent or no power to freezer controls
• Helps resolve symptoms such as controls or display not responding, intermittent operation, or a freezer section that won't run due to wiring faults
• Restores secure plug-and-play connections when original harness terminals are corroded or broken

• One wiring harness for freezer controls

• Disconnect power to the appliance before inspecting or replacing the harness to avoid shock or damage
• Match connectors carefully; do not force connectors together—align pins and clips before seating
• Route the harness away from sharp edges, moving parts, or heat sources and secure with existing clips or tie straps
• If other wiring or components look damaged, inspect those areas; replace only verified faulty parts

This compressor mounting pin secures the refrigerator compressor to its mounting bracket, helping reduce vibration and noise for reliable operation. It's a simple, rugged fastener used where the compressor meets the cabinet base. What it does:

• Anchors the compressor to the mounting bracket to limit movement and vibration
• Helps reduce compressor-related rattling or banging noises during operation
• Maintains proper compressor alignment to protect refrigerant lines and electrical connections
• Works with existing mounts and brackets as shown in OEM diagrams

• One compressor mounting pin

• Disconnect power and unplug the appliance before accessing the compressor area
• Support the compressor and attached lines before removing or installing mounting hardware
• Use appropriate hand tools and follow OEM diagram locations for correct placement

A spill-safe glass shelf that contains spills and keeps refrigerator items organized. Fits into existing shelf tracks to help prevent liquids from dripping to lower shelves and drawers. What it does

• Provides a sturdy, flat surface for storing food and containers.
• Raised, contoured edges help contain spills and make cleanup easier.
• Replaces cracked, chipped or missing shelves to restore usable storage space.
• Helps keep leaks from spreading to lower compartments during accidental spills.

• Remove food and support the shelf while sliding it out of the shelf tracks to avoid dropping.
• Align the shelf with the side tracks and slide it fully into place until it seats securely.
• Clean with mild detergent and a soft cloth; avoid abrasive pads or harsh chemicals.
• Handle glass carefully and dispose of broken pieces safely; wear gloves and eye protection if removing damaged glass.

Specs: Hex head , 8 - 15a x 1.000