Kenmore Refrigerator 253.70532401 (25370532401, 253 70532401) Parts

This is a Plazcrew #8-10 screw used to fasten appliance panels, trim and components. It replaces lost or damaged screws to restore secure fit and reduce rattling or loose parts. What it does:

• Secures panels, brackets, trim pieces and small appliance components
• Restores proper alignment and prevents vibration-related noise
• Replaces missing or stripped fasteners that cause loose or wobbly parts
• Matches OEM fit for repair and maintenance where this screw is specified

• Disconnect power and follow appliance safety procedures before working
• Use the correct sized screwdriver or driver bit to avoid stripping the head
• Tighten until snug; do not overtighten to prevent thread or component damage
• Keep small parts away from children and work over a tray to avoid loss

This trough drain is the molded drain channel that guides defrost and condensation water safely to the refrigerator drain system, helping prevent puddling and water damage under the cabinet. What it does

• Collects and channels meltwater and condensation from the evaporator/defrost area into the drain outlet
• Helps prevent water pooling inside the freezer or under the fridge base
• Reduces risk of ice buildup and recurring water leaks in the cabinet
• Restores proper drainage when a cracked or clogged trough causes overflow

• One trough drain

• Disconnect power to the appliance before starting any repair
• Remove food, shelves, and access panels as needed to reach the drain trough
• Inspect surrounding seals and the drain tube for clogs or damage when replacing the trough
• Follow steps for proper removal and reinstallation; use OEM fasteners and gaskets if required

This access cover is a replacement access panel that protects internal components and closes service openings for safe, finished appliance operation. It restores a secure, clean appearance and prevents debris from entering service areas. What it does:

• Covers and protects internal components behind service openings
• Keeps wiring and connections enclosed and out of reach
• Prevents dirt, lint, and small objects from entering service areas
• Restores a finished look and secures loose or missing panels
• Helps reduce drafts through service openings

• Disconnect power (unplug or shut off breaker) before installing
• Use basic hand tools; align tabs or screw holes before fastening
• Handle edges carefully to avoid cuts and prevent damage to surrounding trim

Made of Nylon with adhesive tape

This outer freezer door panel restores the exterior appearance and protective surface of the freezer door. It replaces a dented, scratched, or corroded panel so the freezer looks finished and resists everyday wear. What it does:

• Replaces the damaged outer surface of the freezer door to improve appearance.
• Protects internal door components and insulation from impacts and moisture.
• Helps seal and align the door edge when installed correctly.
• Commonly replaced for visible dents, scratches, peeling, or rust on the door exterior.

• Intended for replacement by someone comfortable with appliance trim removal; retain all screws and clips during disassembly.
• Disconnect power (and empty the door area) before starting to avoid injury and damage.
• Handle edges carefully to avoid cuts and protect finished surfaces from scratches.
• Fit and final alignment may require minor adjustment of door trim or hinges; follow OEM diagram for correct fastener locations.

Specs: 4 - 24 x 0.750

Specs: 4 - 40 x 0.375

Galvanized Steel